We would like to be able to calibrate the rRF9E5 ADC
Our proposal is to permanently fit voltage dividers, each using two precision resistors, on two of the ADC Ports and...
At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hi all
have used the LIS2DH successfully with the nRF52810, now have upgraded to the nRF52832. The SPI lines are not working at all i.e. when I scope them they are all...
Hi all
Will like to know what is the most suitable programming language to program Nordic Microcontrollers and do Nordic provide any software training for developers regarding...
Platform: NRF52832 custom board. SDK11 S132 V2.0
Produced 2600 pcb's. Most function as expected. However, 40 or so boards run normally only when using the debugger. The...
Vdd generated from Vddh is unstable without connected debugger and with non-started soft device
We are developing a battery powered device based on nRF52840 on custom PCB...
I'm using nrf52 S140.
We have a working product that exposes various custom services and charateristics. However, in nrfConnect these are extremely hard to understand because...
On SDK16.0.0 + Mesh SDK 4.1.0
I am getting random softdevice asserts when running our application with TWI accessing a temperature/humidity sensor (HTU21D/HPP845). Sometimes...
Hello,
I merged the two projects usbd_cdc_acm_pca10056 (A) and ble_app_hids_mouse_pca10056_s140 (B).
Currently, I'm trying to make it running again by line by line add...
Hi there!
Let's start by explaining why this is necessary. Every device will contain an RFID tag and the RFID tag number has to be equal to the address of the device it...
I have made a custom board using NRF52832 (NRF52832-QFAA-R/QFN-4) with 32MHz and 32.768 kHz crystal. The SDK is nRF5_SDK_17.0.2_d674dde. It can be connected using nRF52840...
During the initialisation adding gatt attributes with the function "sd_ble_gatts_characteristic_add" i get the error NRF_ERROR_NO_MEM. So it seems the default table size is...
We have Thread devices with bootloader and applicaion based on nRF5 SDK for Thread and Zigbee 2.0, and now we are migrating to SDK 4.1. As it's stated in documentation the...
