But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
I did current measurement on nRF5340 DK with PPK2 kit.
I’m using the Ampere Meter Mode, and cut the SB40 on nRF5340 DK.
Test Setup: Ampere Meter Mode
Window Testing...
Hello All,
I am just facing an issue w.r.t monitoring the ADC pin with certain threshold voltage. I am able to read the voltage level using SAADC driver on that pin and...
Hi
In my app i need to keep in sync client/server communication, which means no packet is sent in any direction until the sender got the confirmation from receiver for the...
I can't see any headers for this board and MCU in the current 17.0.2 SDK. Are board headers available anywhere yet? Should that be pca10095.h or something else?
Thanks...
Hello all i want to do a task that is control another LED using ble_app_blinky. In the ble_app_blinky project a characteristic is used to control an onboad LED. I have connected...
After 3 days of debugging and hours on the forums trying out various things, I just wanted to post a mini quick start guide to getting low power working. Turns out that all...
Hi Guys，
I want to implement a Vendor-defined USB HID device, But encountered the following problems:
1.When the PC sends data via USB HID , the slave(52840) cannot enter...
Since SDK15.3.0 the DFU example code has changed to require signed DFU commands.The DFU that we used is base very closely on the Nordic example. In our update process we have...
Hi,
I am facing an issue with the RSSI value when my device is in connected mode.
First, in ble_evt_handler(),
in the BLE_GAP_EVT_CONNECTED case, I place the following...
Hi I am using NCS version 1.5.0 and DK version 1.0.0
If I want to build any application using nrf9160dk_nrf9160 Im getting the following error.
Traceback (most recent...
Hello, We are about to release a Firmware update for our vibration sensors and we are now testing the consumption of the new firmware. Our sensor is a nRF51822 + Accelerometer...
