But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello,
I am using nRF52832 with Temperature sensor using sdk 16 version . I have done buttonless OTAin ble_app_uart example by adding the dfu in it . I can able to update...
Hi,
I meet a hard fault handler issue when initialize the saadc channel. The code is as followed.
When I set the breakpoint at line 22, the debugging process can work...
Segger Embedded Studio V5.20a / SDK13 (file structure from a legacy project) / BLE / ANT+ s332 4.0.5
I am in the process of moving from command line build (armgcc make...
I'm assuming AGPS in the Asset Tracker was designed to use nrf cloud. I don't know if that will be suitable for production deployment at the moment. The GPS with SUPL sample...
Hello,
Our customer want to know how to know the ZR and ZC is lost for a sleepy end device.
I check with the document.
For ZC ,
i fund ZB_NLME_STATUS_INDICATION event...
Given a peripheral with BLE services A and B, if I advertise B but add A first during my services_init code, then the 16 bit UUID portion of B is added to A's long UUID. Is...
Hello ,
I am using NRF 52 DK board and SDK15.3.0 .
I have tested \examples\peripheral\blinky_freertos code and its working fine .
but the same code ( in that code ,...
I have a custom board with nRF52840 (with SDKv17.0.0 + s140_7.0.1). I'm making a BLE peripheral out of it, but it disconnects after 2 minutes. Things seem to work fine during...
Hello,
I have been struggling with managing power consumption of my nRF52832 so it can stay low. I'm using nRF5_SDK_17.0.0_9d13099. I did some extensive search on the available...
Hello All,
I'm updating an application for the nRF52840 that requires it to enumerate and act as joystick. I'm able to run the HID generic example in SDK15.2 on the BMD340...
Target is nrf52832+SoftDeviceS132
When run ActiveScan,
Is SCAN_RSP advertise_report notified only after ADV_SCAN_IND advertise_report?
If I receive only the SCAN_RSP...
I used nrf9160 DK with sim LTE in Vietnam to run mqtt_sample. LTE link successful but I received the ERROR: getaddrinfo fail 51 and mqtt_connect 41. Please help me to solve...
