Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hello,
I'm trying to create a PC application to read out some Ti Sensor Tag modules. I'm using a nRF51822 USB dongle and the Master Emulator api.
The nRF dongle sees...
Hi
I have my code like this .
unsigned char *encryptedData;
unsigned int encryptedDataAfterAppendingLength;
memset(encryptedData, 0, encryptedDataAfterAppendingLength...
Hi, I'm investigating the current consumption of a new product that we are developing and have found
current spikes of 40mA every 24ms. The spikes occurs in unconnected...
HI,
I get confused using the ble terms hence i'll try to articulate my query as much as possible. I'm using the nRF52832 board and all i have one service with one characteristic...
Hello,
I want know what is the difference between the three kind of low power mode?
System ON, Full 24 kB RAM retention, Wake on GPIOTE input (Event mode) System ON...
Hello
I am trying to get the angle of the sensor using the value of mpu6050.
I used a formula to obtain an angle using sensor values. However, if I calculate this expression...
Hi,
I´m using SDK v16 on a custom board and try to implement the wake up functionality of the low power comparator. In order to describe the system as clearly as possible...
Hello.
I am programming the NRF52810 breakout board.
Before I am testing the prototype, I am using NRF52832 breakout board, and it works well now.
However, the same...
Hi Dev Team,
I was working with the nRF9160 and started off with the basic UART sample found here : https://github.com/Rallare/fw-nrfconnect-nrf/tree/nrf9160_samples/samples...
Dear every body,
some days before, i raise an issue relate my fault at here: https://devzone.nordicsemi.com/f/nordic-q-a/68010/nrf52810-issue-with-32mhz-external-clock ...
Hello
I'd like to reset using the firmware instead of the reset button on the board, is it possible? I'd like to reset the entire Bluetooth connection when it's disconnected...
HI，ALL：
Now, I am study frequency hopping.I found something might be different. It is more hard from highest frequency to lowest frequency(the same as lowest frequency to...
Hello
I use nrf52832 and SDK v17. I am programming BLE using UART service. So far, there has been no problem with testing with one phone, but if I disconnect the Bluetooth...
Hi, all
I'm using nRF52832 pca10040, s132.
Like 'ble_app_hrs' example, I changed the 'ble_app_uart' example to send data using app_timer.
In the example of 'hrs...
