Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
I'm looking for the quiescent current and efficiency of REG0 DCDC under the conditions of 3.0v ≤ VDDH ≤ 4.2v, VDD=1.8v.
This is to determine if external regulation using...
I have a SparkFun Pro nRF52840 Mini that I am trying to flash with a simple Hello World program. I have the SDK setup in Visual Studios, created the custom board configuration...
I have this code developed for nRF5340.
Basically it scans for BLE advertisements based on the filters added and transmits the packets through UART.
Now for certain reasons...
Datasheet sampling rate is 100Ksps, but for me PPK2 always returns:
16384 bytes in ppk2_test.get_data() (one sample period)
4096 analog samples in ppk2_test.get_samples...
Hello Nordic,
I want to power down (at the lowest power consumption state as possible) all the peripherlas.
Already checked below ticket.
Below ticket also referenced...
hi,
I use softdevice s140 and nrf5_sdk_17.1.
I import time sync demo from here ( github.com/.../nRF5-ble-timesync-demo) to my project.
My first usage version:
* nrf52...
Hello,
I’m encountering an issue with my nRF52 device where it reboots during the flash_erase operation. Below is the relevant part of my code and the overlay configuration...
Hello all,
I'm using nrfx_spim_spis non_blocking sample to make my nRF5340 DK as SPI SLAVE.
I don't need SPI MASTER, so I delete the SPIM code.
But I found that I can...
Hi,
Is there any relationship between RTC peripheral and the system clock (which from DTC it looks like attached to rtc0)?
I'm trying to use PPI to generate a radio task...
I am looking for a solution of a multi-protocol controller for Linux host.
1. Coexistence of Wifi & BLE & Thread / Zigbee
The ble-coex / thread-coex example has the...
I'm trying to do a power analysis of an embedded device with a PPK2 and nRF power profiler and i'm running into an issue where i'm losing samples on longer capture periods...
I have a simple Thread joiner program. I am trying to join to a thread network created by my OTBR. Attached is my program. This program resets on call to otJoinerStart()....
Hi,
We use SDK 2.5.2 on a nrf9160. And have a hardware issue due to a too late update with the first boards. The GNSS LNA enable is wrongly connected to COEX1.
COEX0 is...
