Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
Having in mind an application that is comprised of two nRF devices (can be two 52833 or 5340 or any combination of these).
One to act as a Central, the other to be Peripheral...
Hello.
I have my application created by referring to "ble_app_buttonless_dfu" example.
When I applied for certification with this application, it was determined that this...
As you know, FDA check issue that is SWETYNTOOTH for all BLE Solutions to apply for medical solutions
So, My customer requested that is checking free from SWETYNTOOTH issue...
Hi,
According to comments above bt_mesh_time_cli_time_set of time_cli.c , if the last parameter is NULL
the function is non blocking:
However, the function returns...
I connected my device over BLE with the computer and currently using Bluetooth LE Console from Nordic. The Console is receiving data and that is good, but I do not know how...
I'm running the radio_test example on an nRF52840, but when I try different modulation duty cycles, it seems to work fine for everything less than 94% however 94% itself starts...
Hi Nordic,
I got the following error when I start nrf connect the first time under MacOS. This log is captured by turning on the Debug console:
Uncaught Error: dlopen...
Hello,
I am sampling two analog signals at different sampling rate with burst and oversample enabled.
nRF52832 (Rigado BMD-350)
SDK 15.2
IDE - Segger Embedded Studio...
Hi,
I just got my custom nRF5340 board and started testing it. Here's what I've done:
Connect the board with JLink v11.
Erase the board with Programmer on nRF Connect...
Hi I trying to develop a module in the 52810. I want use te ble_app_beacon and add a DFU buttonless. I was able to add the DFU, but when i was to integrate the buttonless...
Hi, i am Karls of Gabsjin in south Korea.
Sometime ago, i happened to know something controlled by mobile(smart phone)
So I would like to make a avr circuit controlled...
Hi,
I built a peripheral unit which working on NRF52805 with SDK17 (S113/S112).
The unit needs to be "multi peripheral" and advertise 2 different advertising packets simultaneously...
