But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello, I follow
this page to start the rpi2 for 6lowpan.
when I tried to run RADVD Daemon as follow:
Set IPv6 forwarding (must be present).
sudo echo 1 > /proc...
Hello!
I recently purchased a RedBearLab nRF51822 board where I want to use several DS1820 temperature sensors.
For dealing with the OneWire (1-wire) protocol I found...
Hello,
I'm not sure if this was already asked before. I didn’t found a similar question, so here it is: When I have a function that manipulates a data structure to communicate...
In this ADC example from Nordic on GitHub, it does not appear an AIN has been selected (e.g.: no call to nrf_adc_input_select() ). I don't understand. I have been assuming...
Hi,
I am creating a central application on a Nordic nRF51 device. Our project is related to connecting to peripheral of any profile. Using the MCP I connect, bond and enable...
Hello,
For our application I have to set up two simultaneous connections between a S120 master device and two peripherals that use the S110 softdevice.
A very short connect...
Trying to send 3 20-byte packets of data from nRF51822 (peripheral device) to a Samsung Galaxy S5 (central device) and send 1 20-byte packet back, all in less than 10ms. I...
Hello,
I'm looking to bootloader sources and i want to add a timeout if entering with a signal in DFU mode and no DFU detected for one hour.
There is a timers_init function...
I have a project that requires full-duplex voice comms (doesn't need to be high-quality). I'm evaluating the suitability of BTLE for the task. The new nRF52 has a PDM module...
I'm moving to Nordic from "another" BLE s.o.c. where the UUIDs, profiles, services and characteristics were defined in XML. With that product I could modify or examine or...
