Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
Hi,
Earlier today the forum appeared empty and none of my old posts were visible under profile > questions. Another user also had this issue. The front page looked like...
So I'm trying to follow this tutorial - https://devzone.nordicsemi.com/b/blog/posts/getting-started-with-nordics-secure-dfu-bootloader to generate secure OTA DFU
I've got...
I have set up a simple test to check if scan request can be used as an acknowledgement for advertising packets. I send some distinct advertising packets and multiplex them...
Hi everyone,
sadly my nRF51-DK boards seems to be terribly bricked.
During firmware update nRFgo Studio (on Windows) stopped responding.
I can't enter bootloader mode...
Hello,
I am currently trying to add SDK15 functionality to a mesh project as shown in the documentation.
http://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic...
Hello,
I am working on a project with nRF51822, I want to connect two or more nRF51DK boards using SPI and send an interrupt from one board to another, Is there any code...
Hi Nordic,
I am using SDK 12.3.0 and S130 2.0.1. I would like to ask some questions about Peer Manager.
1. I want to erase all bond when I press a button. Do I just...
Hi,
I have been trying to read the register values, from BNO_080, using the functions nrf_drv_twi_tx to write and nrf_drv_twi_rx to read. But for some reason, i have been...
Hi!
I gave up trying to come up with a working solution for updating mesh nodes based on SDK1.0 to SDK2, see https://devzone.nordicsemi.com/f/nordic-q-a/37707/dfu-update...
Hi,
I read this post to handle communication with both built in UARTs
I'm working with Mesh SDK 2.0.1 and nRF SDK 15.0.0 at the moment.
My application uses UART0 initialized...
I noticed that the secure bootloader by default protects bond information during FOTA. In earlier SDK versions there was something called preserved pages right below the bootloader...
Hi, Im using this library, https://github.com/NordicSemiconductor/Android-BLE-Library/, Everything works great except the disconnect part, I need to press the disconnect button...
I had setup nRF sniffer with below software and hardware, but the Wireshark seen unable capture BLE data.
nRF Sniffer software nrf_sniffer_2.0.0-beta-1_51296aa.zip ...
