Dear all,
after cutting the SB bridge to the QSPI chip and close the ones to get the pin free and disabled also qspi inside the nRF52840dk_nrf52840.overlay file I'm unable...
Dear all,
I stubled upon the following issue when developing a BLE sensor product. When I try to bt_gatt_notify(); With only one characteristic, there is not an issue...
I was looking into the sdk provided by nordic for nrd52840Dk board and want to test the zigbee protocol. I havn't find any sdk for that.
Can you share me some links and...
Hello Team,
I want to configure P2.07 as UART RX for my custom board.
But when I clear the already assigned property as led2 for this pins from the pin editor gui, I am...
Hi,
I am trying to adding a coded phy support on my device in NCS project.
once I added CONFIG_BT_CTLR_PHY_CODED =y in my config , the ROM size will add more than 7kB...
Greetings ...
I am facing problem in finding a coexist example for P10056. Example code is given only for PCA10040.
1)Is there a way to convert the PCA10040 code to PCA10056...
tag v1.1.0 (have done west update)
using SES 4.30c as suggested by nrf connect (latest SES did not work for me either). Compiled and flashed using SES
simcard inserted...
Hi, I've downloaded Segger from https://www.segger.com/downloads/embedded-studio/ , upon install I found that all of the nRF tabs were missing in this version. Looking through...
F:\nRF5_SDK_16.0.0_98a08e2\examples\ble_peripheral\ble_app_uart
I tested above example, found the speed only 3K per second. Do we have a way to increase the speed?
Hi,
I'm using an NRF51 Dongle as a central to connect to a BLE peripheral using LE Secure passkey pairing. I've got to scanning / connecting successfully, I'm just stuck...
Hi, is it possible to control mesh devices from outside the network ? My idea is to control the light servers inside mesh network via the user interface provided by Home Automation...
Do you have "technical" documentation for examples executed with Python?
I need to send those packets from my host controller, which does not run python.
Something like...
In case the DSM metadata is changed compared to what is stored on flash, the 4.0.0 code is supposed to clear the flash from any configuration but this doesn't work properly...
Hello,
I'm pretty new to rtos and totally new to nordic's nRF9160. I've been trying to get this working all day and can't really seem to figure it out based on the resources...
Hello,
We are using nRF52840 with SDK 15.2.0, a bootloader, the bootloader settings and the SoftDevice. Our product has a cellular modem to be able to perform OTA firmware...
Let say a situation where I want to know if the just connected client is the same as the one that was last disconnected, but if the client uses RPA than have somehow to try...
Hello,
I'm developing a BLE device based on nRF52832 and SoftDevice 112 using SDK 15.3.0. The device operates only in peripheral mode with only a single connection to the...
Hi
I try to run BLE HRS collector example.
when I run the project, in RTT terminal I have these error
00> sd_ble_enable: app_ram_base should be adjusted to 0x20001CD8...
