Hi, I'm currently in architecture definition stage, and I'd like to know more about the possibilities driven by Channel Sounding. From what I understand, you can only perform...
Hi,
I am encountering an issue with the TWIM driver when attempting to communicate with the nPM1300 PMIC via I2C.
This problem seems to be related to the behavior of the...
I have been trying to implement a way to wake the system up after doing sys_poweroff() but no matter what nothing seems to work. I already tried many examples and none of...
Hello,
I have been able to get FW OTA to work perfectly well over BLE using
CONFIG_NCS_SAMPLE_MCUMGR_BT_OTA_DFU =y
Now I am trying to display the update progress...
The custom AT command "AT%XICCID" was added in modem firmware v1.1.3 for the nRF9160 and was available from the first release for the nRF91x1.
This command provides a processed...
Hello,
Is the NRF7002 pre-certified for the RADIO EQUIPMENT DIRECTIVE 2014/53/EU (RED directive) ?
Is there a recommended antenna design that would ease certify a product...
Good day, I was attempting to test the radio performance of the NRF54L15. I ported over the Radio_Test sample project to try and transmit an unmodulated carrier wave at a...
I have the RedBear BLE shield running on an Arduino Leonardo. I am using the ANCS Library from here: github.com/.../avr_nrf_ancs_library and have updated it to run the latest...
Hello,
I am currently working on a project that requires my analog signal to swing below and above ground. I was wondering if the ADC of the nrf51822 would be able to support...
I'm new to the Bluetooth LE world, and Nordic in particular. We have begun developing a system that acts as a Bluetooth master, and I am trying to figure out a way to test...
Hi everyone, I have just started using the s120 softdevice to implement a Central BLE device. The starting idea is to start with scanning and reading the advertisement data...
Hi,
I have seen several answers about how to achieve a higher data rate and I just want to make sure what I understand is correct.
I am using nRF51822 chip and the dongle...
I am developing a product using nrf51822 v5.2 SDK.The question is that Ble will automatically disconnect in some minutes after normal connect OK.The message by Sniffer is...
Recently while debugging my application i noticed strange behavior:
i set watchdog timer to restart application if my peripheral is not receiving any data for some time....
I have a nRF51822 Evaluation kit I am trying to get up and running. My kit has the older QFAACA part.
I followed the steps to setup eclipse and GCC and i am successfully...
Hello,
I took the ble_app_hrs rebuilt it and used Control to verify all is correct. I also tested it with the nRFTools Android App and it works fine I see temperature changing...
Hello,
I am currently starting with the hole ble topic. This forum helps me a lot in the last weeks to understand ble.
I am using S110 to provide a peripheral device...
I use the nRF51422 with S310 stack and i found the nRF51422 power consumption are quite different after connection on different phones which run the Master Control Panel as...
I have written some code that uses the SPIS to transmit data. One of the bursts is constant, for example I have a fixed sequence to send using the SPIS and so if I define...
