Hi.
After 3 days I've finally got littleFS working on a custom nRF52840 board. I am using nRF connect SDK v2.9.0 which includes Zephyr v3.7.99 with some additional Nordic...
Hello, I am working with a nRF54L15 and using a TF-M build (cpuapp_ns). SDK and toolchain are currently v3.0.2. NRF_SECURTY is enabled (by default) and here's the relevant...
Hi,
I’m working on a Matter application using the nRF Connect SDK v2.9.2 . I’ve added the AirQuality cluster into my device with sub-sensors: CO₂, PM1, PM10, TVOC, and Temperature...
Steps to reproduce the problem
Create a new application based on the Matter Light Switch example of the SDK 3.0.2
In prj.conf set CONFIG_CHIP_FACTORY_DATA_BUILD=n
...
I would like to do a FOTA using bluetooth and external flash memory on nrf52840 board. I am also using sdk 2.9.1 The issue i am currently facing is I get the below when i...
Hello nordic community,
i have custom board that have nRF5340 and nRF7002, our requirement is to use wifi every 5 minutes (connect send data and disconnect) but randomly...
HI,
I am using the periodic_adv_rsp example from version 3.0.0. I would like to ask how to switch channels and transmission power in the example code?
Thanks.
Hi,
I am using legacy version of DFU for my application and would like to use the appropriate version. However, using pip the only available versions are 1.1.1 and beyond...
Dear NORDIC
I have one strange issue:
My nRF52 app work well, then I use Android phone connect to it, it's OK.
Then Android phone cancel pair, so nRF52 disconnect,
...
i want to run simple compiled example .its very basic question.i need your to take start ??which example i compiled first and what the devices i have required to test it
Hi,
I've been debugging my code and would like to use the Memory Watch Unit (MWU). I use SDK version 11, s132, and NRF52.
Could you point to an example of using MWU...
Hi all, I'm using SDK 13 and after turning on the HF clock, calling the following code. When I queue a TX packet, there are no errors from any of the nrf_esb_...() calls,...
I developed a bootloader and an application using PCA10040 and all works fine, but when I set the same code to my custom board (that use the same chip) I get a very strange...
Hello,
I have an issue regarding using IAR tools with the examples provided in SDK v13.
I have:
nRF52840 Preview DK
v13 of the nordic SDK ( www.nordicsemi...
Issue when using SDK 12.2 which needs to be fixed in SDK:
sdk_resources.h will not build when included from C++.
This is because start extern "C" {" is placed in wrong...
Hey Guys,
Please pardon me if this is stupid question, I am trying to create a development board with nrf52832, and I want to have a debug probe on board.
I found open...
Hi,
I am using SDK 13.0 and tried to burn in fresh example code (Experimental NFC BLE Central Pairing Reference) to either PCA10040 and PCA10056. However both always shows...
I noticed that having the UART enabled on my application in a NRF52 (SD132, SDK 11.0.0) takes a lot of current consumption. If I completely disable any UART support on my...
