I am trying to make a product with NRF8002B. I finally have the product prototyped. The user will connect to the device, beep, light up, and track. It will always stay on...
Please,
It seems that "Flow Control" signal is not available on nRF24AP2-USB.
EVENT_TRANSFER_TX_START event message appears only one time after the first data packets...
I am looking for cheapest (up to few hundred USD) and simplest Arduino basic solution to track real-time RFID tags distance (also direction if possible) without additional...
Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
Hi all,
I took the example SPI program and I am trying to add UART code to it to debug the SPI transfers. Both examples are working well for me separately. I was able to...
I am working one one star network system with NRF24L01+. I got success with one pair (Single TX and Single RX) on communicating. But I could not get any positive result for...
Hi,
I'm working with an SPI FLASH chip that has a page size 256. I noticed that when I call nrf_drv_spi_transfer() , the rx length of 256 rolls over the uint8_t container...
Why the SPI clk doesn't work, i checked using an oscilloscope :/
I also don't get any SPI interrupt and no data change in the RX buffer although I have wired MISO and MOSI...
Hello,
I just encounter a compatibility issue between the two SDK (11 Vs 12).
So i have so product on the market base on SDK V.11.0.
I m developping an update based...
Currently I am facing strange issue in my project. Let me first highlight my set up. I am using the PCA10040 kit for development, keep multi-meter in series to measure current...
hi experts, I want to build a ble center based on s130 to collect sensor data from several peripheral devices. Some of them may not be from nordic solution, such as TI. so...
When I connect to my firmware after cycling Bluetooth on iOS, I am able to subscribe to my Characteristic Indications without any issues. The nRF connect app receives all...
I have two boards, one is official demo board, the other I make PCB board.
I down the open-mesh source code form github.sdk version is 8.1,open mesh stack version is 0...
Hi,
I have to send data with notification from central to peripheral, because I need save some data in peripheral device.
What I have to do ?
I test it on Adnroid 4.4 ...
Hi Sir,
I am working on nRF52832 board with pca10036 cortex M4, and i worked out spi master and slave example code on a same board and configuring spi instance 0 as master...
