Hi,
I have two CPU in our product. (STM32F2 and Nordic nrf51422).
I use serialization function to link those two CPU(refer to ble_s110_serialization sample)
But I find...
Hi,
My behavior is as follows
Turn on my device(use 51422) and advertising(2 Service and 3 Characteristic)
Turn on my cell phone(Samsung Note3),scan my device...
Hello:
I used analog IIC write MPU6050. Again after power download programs, mpu6050 can run up there ACK response. But the debug will not run. Simulation IIC because no...
Hello!
How can I communicate with my nRF24L01+ and nRF51822 at the same time. I can set up same channel, CRC-mode and I don't use ESB. But what about address? How do I set...
Hi all,
i want to know answer related to following question
1)what is use of uicr?
2)if i place some value in uicr and then change the image,then is there will be change...
It used to work, but now it says "Connected" but the rest of the GUI never changes and the mouse just shows a busy spinner. Here's the log file:
0;13:45:18.9900 [MainThread...
Hi all!
My question is:
My own application is built based on the example "ble_app_template", and according to the nrf51 SDK - Examples - BLE Peripheral, this example...
Hello, as it is clearly understood (by everyone developing using NordSemi's SOCs), this struct "ble_evt_t"
Hello, as it is clearly understood (by everyone developing using...
Hi,
I've read in your press release for SDK 12 that increasing the MTU beyond 23 bytes is now possible on the nRF52. I thought I'd test this increase out on my nRF52 with...
Hi All,
I have a basic question, i want to know what are the right value to use with the nrf51422 chip for the resistors with ADC.
I want to use the maximum value permitted...
Hi, I have problem with using example codes. I want to add GPIO control to ble_app_uart example. Adding gpio_config() function taken from app_timer_tutorial blocks program...
I'm using NRF52832 SoC and IAR
I've to read data from ADC using SPI. ADC will generate interrupt every 4ms indicating data ready. I've configured GPIOTE to sense the ADC...
A couple of power consumptions Q's for this basic scenario: RTC used via PPI to infrequently sample from ADC and trigger SPI read from external sensor source.
Questions...
Hello,
I need a support for BMD-300 BLE module.
We can flash the BLE module and we can connect it with mobile application via Blue-Tooth.
But when we flash BLE for...
Hi,
I'm using nRF51822 in my senior project (some kind of BLE wearable device).
I'm trying to call my function inside the ble_evt_dispatch() function but it doesn't...
SPI Slave configuration On nRF52
Hi,
I am trying to configure the SPI slave peripheral for interrupt based communicaton with a SPI master
In previous work with ARM...
Hi,
Can any one tell me about all the security features provided by nrf51822 s110 for secure communication?
Share me some example that implement encryption durring communication...
I have a problem with bonding with a static passkey. I have some sensors, which have a static passkey hardcoded in them. If I want to bond with them, I have to provide this...
Hi, I'm new with BLE applications and I'm designing a wearable.
This wearable will be powered with a CR2032 coin cell battery and I'm wondering if you recommend to use some...
