Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hi,
> Context:
I run a baremetal application that I would like to enhance with bluetooth.
I am considering a BLE module from NS.
I currently have a SoC (nanopi...
I have created a nRF52 based peripheral device which is used to stream sensor data to a connected central device, usually an iPhone. I can stream data, reliably to the iPhone...
I have an odd situation. I've been using an iPhone 5 and 6 to connect to, and test against, both an nRF51 (redbear nano) and the same code built for nRF52. It works fine....
Hi All,
i am using nrf51822 with SDK 12 and i am not able to find where All BAUDRATE Macro is defined for APP_UART.
so anyone can tell about that in which file it is...
I looked at examples and added identical code to my own app, specifically to a) set the gatt_enable_params.att_mtu to GATT_MTU_SIZE_DEFAULT, and b) to handle BLE_GATTS_EVT_EXCHANGE_MTU_REQUEST...
Hi,
Is there an extensive documentation about programming process of a nrf52832 using keil?
I just spent hours figuring out that I had to use Softdevice erase flash algorithm...
I just followed "Testing the example manually (without bonding)" steps to manually update firmware by Master Control Panel.
But every time, I got log message, "SERVER:...
I am implementing mqtt client on Nrf52832 with the example provided in the IoT SDK. I am looking for the correct way to make the client to run with Non-Nordic socket stack...
I've just finished my first layout for nRF51822, and I need a help with the attenna design.
The RF part of the schematic and layout is a copy of your reference design, "PCA10004...
Hi
I'm using BLE400 board (from waveshare) which have a nrf51822 chip on it. When I want to program the softdevice with nrfgo I encounter the following error:
link text...
Hi, I got a problem.
I created a timer, interval is 30ms.
#define MIN_CONN_INTERVAL MSEC_TO_UNITS(150, UNIT_10_MS) /**< Minimum acceptable connection interval (0.02...
Hey Guys,
I am trying to create a workflow for creating new project from scratch in eclipse, traditional way with nRF5 sdk provided make file is not scalable and it really...
We are using a MMA8452Q accelerometer connected to an nRF51822 via TWI using the twi_hw_master. Reading the WHO AM I register is the first attempt to get the TWI running but...
