Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi,
Im trying to send data via the NUS service which is larger than 20 bytes. I understand that I have to break down the data into chunks in this case, which is what I...
I am new to embedded programming.
I use JLINKEXE (on Mac) to load the S110 softdevice and my application. When I am in the debugger, the app loads and all runs as expected...
Hi there! Running a bootloder of sdk 9.0 on nrf51822, a problem occurred in a special way. In a normal way, program softdevice and bootloader with studio respectively, then...
I will write time to my ble device and need write uint32_t via characteristic. When i try only (uint8_t)data[0] is correct.
How can I do writable characteristics (uint32_t...
Hi,
I have a peripheral device with custom Services and characteristics which is working properly (I can tell because it got tested with nrf Master Control Panel app)....
My PC completely bricked so I'm setting up Eclipse and GCC on a new Machine. Everything seems to work except I'm getting two odd compile errors on INLINE functions. The compile...
Hi,
i am using blend micro with nRF8001 .. i want to make the bluetooth module to sleep on an interrupt such that it should consume the lowest power.
thanks in advance.
I want to use Seggers RTT for data logging.. but after 199lines the Viewer starts to overwrite the old lines.. so that only the most recent 199 lines are displayed..
Are...
Hello,
I want to use nRF8001,but I'm a beginner for nRF8001,I have no idea how to start my software design.
Could anybody give me some guide about how to start my design...
Hello Everyone
i have been trying to implement the pwm library from the GITHUB inorder to make the buzzer beep sound but after compilation it is showing these two errors...
i want to add a characteristic readable that hold a device TimeCount; timeCount is increasing;
ble client (andorid) can read the characteristic at any time;
how can...
Hello,
I'm going to start a new design based on the CSP 3.0 x 3.2 package for nRF52832 (CEAA version), I already find the reference information for the QFN 6.0 x 6.0 package...
