But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
I have some code that works great on the Eval Kit. I would like to move it to the smaller form factor Beacon kit. I currently use the S120 SD. Is there an easy way to install...
Hi
The BLE module operates in 2.4 GHz spectrum with 3 advertising channels & 37 data channels . Why advertising require 3 channels ? is it possible to make it to one channel...
When I initialize the SoftDevice with SOFTDEVICE_HANDLER_INIT(NRF_CLOCK_LFCLKSRC_XTAL_20_PPM, false); // Sets up Crystal Source to 20ppm 32.7628kHz
The project I based...
Hi,
First, I understand this are Android questions, but I want to appeal to this very knowledgeable community ;)
I have a BLE application using nrf51822 with SD 110...
int lbs
Hi,everyone,we change the uuid to
#define LBS_UUID_SERVICE 0x2101
#define LBS_UUID_LED_CHAR 0x3A01
#define LBS_UUID_BUTTON_CHAR 0x3A02
in nrf51-ble-app-lbs...
I am writing a custom Service. I need to catch when a Client tries to Read certain characteristics or Write to other characteristics. What is the best practice for Authorizing...
Hello support team,
If a message is received while the timer0 is running and the radio interrupt is enabled, the Radio interrupt hits and disables the timer interrupt....
Hi,
I have a simple application that requires command-response, and notifications interaction between an Android App and an embedded device.
The communication is bidirectional...
Hello,
I wonder how an ANT client should / would / could receive burst data. From what I'm read from the documentation, I guess that the received data will be passed to the...
Hi (I'm new at this, sorry for my question)
About Gazell & Pipe (nRF24LE1)
What is the utility of 6 or 8 pipe, whether only has 3 RX_FIFO for working simultaneous?
Can...
Hi All
I am trying to verify UART on one of our custom boards having nrf51822.
We have only one uart which we are using to forward the data received over BLE.
I am...
I use the demo : ble_app_proximity
to connect with android app
In android use this :
mBluetoothGatt = device.connectGatt(mContext, true, mGattCallback);
to set the reconnect...
