Hi there,
I have recently upgraded my software to latest ncs 3.2.0. I have noticed that my initialisation does complete but it ends up with fatal error that seems to be...
Dear Nordic,
I am debugging a custom hardware with a nRF7002 on-board, using wifi shell app. At this moment the shell does not work as expected, needs to locate where the...
I am attempting to install nRF Connect SDK along with VS Code on an offline machine for development. The main two issues I have are:
The NRF Connect for VS Code plugin...
Hi
I am using the nRF54L15 DK and build a thread continueing monitor the data rate in 1 Hz, if it is lower to 800kbps I want to change to 1M; while above 800kbps I want...
Hi all,
I’m Bruce — first-time poster but have been working with the nRF9160 on and off for a while now, mainly in outdoor, power-constrained telemetry and monitoring applications...
I have a simple GATT server application with two characteristics, RX and TX. In my prj.conf, I am trying to disable pairing as follows :
I can connect to the server from...
Hello,
I am trying to use LTE connectivity on a custom board with a nRF9160 SICA B1, but i am facing issues with the modem.
With both my own app firmware and the sample...
There is a way to set the initial value of a characteristic. But how do I set the value after this without sending a notify to the master? Is it possible to write the value...
Hello,
i want use the port event to trigger timer 1. I need only one interrupt source and i don't want to use the pin event because of the higher current consumption. Its...
are there any cheap watch platforms that use nordic?
i want to make a kid alarm / potty alarm watch
do not want to develop hardware
would use nordic if i can find...
Hi,
when i m using only Proximity . when I use
- (void) centralManager:(CBCentralManager ) manager didPeripheralSelected:(CBPeripheral*) peripheral;*
this method in ProximityViewController...
Hi,
I'm trying to transfer data received from BLE to SPI. When the handler of my service in BLE is achieved I transfer the data I received to SPI.
I know the max that...
Hi all,
I am using ble mesh code, it has version based. For my application( needs to blink led synchronously in mesh) i don't need version part, so i tried with using if...
As your datasheet, External HFXO's Run current is 250uA, but HFINT case is 60uA.
Despite lager current, why do you use HFXO in reference circuit?
I would like to use HFINT...
using **nrf_drv_saadc.**c and nrf_saadc .c nRF52832 with sd132v2.0
for example.
i init a app_timer to update a adc channel per 10ms.
and manually update the batt volt...
Hi
I'm trying to send adc value from peripheral to central. I'm using nrf51822 with softdevice s130_1.0.0 and SDK v10.0.0 .
I'm getting error 3002 which I figured out...
Hi everyone
I am trying to understand if it 's possible to change the clock frequency on-the-fly, by giving a certain command to the uC via UART.
I started from the...
