Hello,
I am using the same hardware, and firmware on 4 custom boards of the same device. I observed that I am getting different current consumptions in each devices.
I...
I’m working with a device that communicates over single-wire UART (half-duplex), where TX and RX share the same line (because the peer device is designed that way). Now I...
Hello,
I recently got a BL653 Click Board and am trying to program it. As I do not have a supported MCU for the NECTO Studio IDE (the ClickBoard's manufacturer IDE), I...
Hi,
I'm looking to use the nrf connect sdk for development that is compatible with the latest zephyr lts. I believe it will be ncs 2.9.2 compatible with zephyr 3.7.99 (3...
I'm still new to this but particularly in regards to battery. I have a custom board with a nrf5340 and have been working on reading the voltage. I used the battery sample...
This is NOT a runtime error it's a compile time error (application). Failing at stage [154/159] Linking C executable zephyr\zephyr_pre0.elf
Having started by following...
Hello,
I am designing a custom PCBA based on the nRF7002DK PCBA and I really need the Fabrication Notes / Drawing that officially went to the fabricator to direct the build...
Looking at Table 40 in the nRF51 Series Reference Manual v3.0, the Memory Protection Unit prevents request sources in Code R1 from writing to RAM R0. But if the request source...
I am facing the below issue that no source is available for "0xffffffff" when i try to debug the program using eclipse
I am using softdevice s110 and have flashed the...
Hi, I developed a sensory application which works together with the Master Control Panel (3.6.0.8331).
On the sensor side I am using the S110 (7.0.0-3.alpha) in combination...
Hi all,
i want a security check on connection that permits only to users that have a password to connect to my peripheral device and, particularly, to read/write on services...
Hi!
I'm trying to test out the glucose example in SDK 11 on a PCA10028 dev kit.
I follow the instructions here: infocenter.nordicsemi.com/.../ble_sdk_app_gls.html
Everything...
I want to distinguish between my customized bootloader builds, for that I added some specific manufacturer data to the bootloader. I added 1 byte of manufacturer, but then...
I have a project to generate audio using a codec. I will store the audio data in hex format on my nrf52 device and with the aid of the i2s interface, I will send the hex data...
Hey guys, I have a question.
Please tell me.
I use the BLE module implementation of the nrf51822.
Now, I try to use sample program "ble_app_hids_mouse" for s110.
I want...
Hi,
I have a application that receives the Epoch time from the Android Application and increments every second. and needs to store and increment the Epoch Time value even...
We just locking for your mesh protocol...
Can mesh example source communicate Ping_pong, Scaling_example, Template by using BLE_Gateway?
Please let me know...
I am using sniffer to monitor the BLE packets.
I noticed that when master is reading the list of the characteristics, sometime there are 2 handles involved, sometime there...
I'm setting up the nRF52 environment on Linux. I have previously used the pure-gcc setup with the nRF51 and that currently works, but since the nRF52 came with all the GCC...
In nutshell, I intend to achieve
Buttonless DFU over BLE on a custom
board with SDK v10.0.0 and Softdevice
v8.0.0 with bonding retained.
On this custom board...
Hi,
I am attempting to make a PCB for NRF51822 and I was wondering how I would upload a bootloader to the chip? I can't seem to find it. The device in the end will be using...
