Hi ,
1.In the example: In nRF5_SDK_17.1.0_ddde560_usbd_msc_1\components\libraries\block_dev\qspi\nrf_block_dev_qspi.c, I need to set the following 0xB7 bytes. How should...
Hi I'm testing the current consumption of the external qspi-flash on nrf5340dk [ MX25R6435F]. I have used ppk 2 to measure consumption with the dk and also have used a power...
Hi,
We are using nrf21540 in GPIO mode + mode pin ( and CONFIG_MPSL_FEM_NRF21540_RUNTIME_PA_GAIN_CONTROL) with an nrf52833.
We are developing under nrf connect sdk 3.0...
During the development of a Matter over Thread product, I encountered the following issue:
After adding two Matter over Thread devices (an OnOff Switch and an OnOff Light...
Hi Nordic Teams :
I would like to check the current consumption by BLE DTM.
1. Is the table measurement is from 3.0V input?
2. I find the condition in the datasheet...
Hi,
I'm writing a driver for a Ublox cellular module, which will be communicating with the nRF5240 using UART. After going back and forth, I decided to go with the app_uart...
Hello, I am an intern at a startup company and ive been tasked with finding some information about the chip set we are using, specifically the bluetooth aspects. We are using...
Hello,
I just installed SEGGER Embedded Studio to build the light switch example for Bluetooth mesh.
I managed to successfully follow the quick start guide using 3 development...
Hello!
I managed to flash my Raytac dongle with debugging going using the SWD on a nrf52 DK. I am mainly working with SEGGER Embedded Studio and nRF Connect on Mac. However...
i m getting constant RSSI values 32 even if i move far or near
this is the same example code in ble_peripherals
I HAVE UPDATED MY CODE (i have printed the RSSI values...
I have an android smartphone of bluetooth version 4 and i am developing one application where i am using nRF52 (bluetooth version 5). Is it possible to write data from the...
Hi, We are developing a device for an Assistive Technology project using Nordic NRF52480. We would like to port to BlueTooth Generic HID (over GATT) an exising device, that...
hi...
I have modified the multi link central to multi link central uart , i can able to connect with 8 peripherals . One central getting connected with multiple peripheral...
I have the nRF52840 DK running a USB HID and an ESB PTX.
It is sending sensor data to a PRX continuously, with ACK.
The end product will be a power-sensitive device, so...
Hi,
I have verified some zigbee functions on nRF52840 and now it's time to consider real deploy phase.
Big concern about deployment of zigbee is
1) how to commission...
Hi,
I am developing a system similar to door lock system.
In our system, user data should transmit from ZED(or ZR) to ZC.
So i modified the ZB_ZCL_ON_OFF_SEND_REQ macro...
Hello?
I need to create 2 events on the same key with two operation like LONG_PRESSED and RELEASE after pressed it. (With precondition no RELEASE event after event of LONG_PRESSED...
