Hi,
i use anRF51822 with soft device 7.
I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5.
Both devices connected...
Hello,
I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
Hi,
i tried to send data from ios 7 via tx_characteristics(like in UART example) but received error:
didWriteValueForCharacteristic 2A38 error = Error Domain=CBErrorDomain...
I have been trying for a few days now to get my environment setup for development with the nRF51822. Since there is no official configuration for the Mac w/ Eclipse I have...
Apologies if this has been asked before but did search for 'format' in faq and got nothing.
I have been answering to questions.
In my answer I place hard empty lines....
Hi
i use nrf51822 s110 "hrs" example to transmit the data to ios.
I need to add an option to send back some data (from ios to nrf51822). 10 bytes maximum .
how can i implement...
Hi
i use the hrs example to transmit the data to ios.
but i need to add an option to send back data (from ios to nrf51822). 10 bytes maximum .
how can i implement...
We are using nRF52811, is there any sample code support to set/save thread power calibration table/data to available non-volatile partition.
thanks, Webber
Hi there,
Can we please get an updated example for Appendix 5 in this blog ?
Specifically the DFUMaster_SPI and the bootloader_secure_SPIS. Ideally it would be compatible...
Hi!
I was trying the throughput example using two nRF5340PDK boards and I observed the throughput is very low, i.e. 1kpbs. I tried programming the cpuappns, but it didn...
Hello! Reading the following segment regarding Buttonless DFU with bonds from the documentation, I'm not clear as to the meaning of these paragraphs. It looks like two contradicting...
Hi
i am able to work with adc 0 for nrf9160 custom borad now i want to use adc 5 to adc 7 simultanuously can you please guide me to settings which i need to modify or a...
Hii guys ,
I am trying to pair two nrf52 bluetooth devices. How can we pair two stand alone nrf52 devices to send and receive data? Is there any example code to show such...
Hello community!
I have curious problems with the bootloading process in SDK 17.0.2 . What I am trying to do is the following:
1. Create a bootloader settings page with...
Hi there!
We are using nRF52840DK development kit with nRF-Connect SDK to build a pre-production version of our product.
We need more GPIO configurations for our project...
Hello Nordic, I am currently trying to develop an application that would send data via satellite if there is no LTE coverage but I don't see any relevant documentation regarding...
I am currently using the ble_app_template code from examples\ble_peripheral in SDK v10. The code and BLE read/write function successfully works. I now want to combine the...
When I publish messages to the mesh network via a Vendor Model, after connecting to device and performing a successful vendor command sequence, I start sending publishes of...
Helo, I am developing a BLE product, and @ encryption stage, I get thie message on the topic.
I attach my log for further information.
The log entry that gives the...
Hi. I am currently using an nRF52840 DK board and SDK 17.0.2.
I require 16-bit heart rate service UUID to work with a 128-bit vendor specified custom service.
When I create...
