Suppose a nRF9E5 transmitter is set for continuous transmission on a channel.
A nRF9E5 receiver listening on that channel:
finds carrier and sets CD
finds address...
I will be deploying my nRF51822-powered devices into the field and the end user will not be able to have any physical access to, for example, power cycle the board. I need...
Hi,
We are using the ble_app_uart example in evaluation board to read data from some sensors and send it to the nRF UART V2.0 in Android 4.4. Every 20 ms I am trying to...
I am try this at nrf51_sdk_v6_0_0_43681\nrf51822\Board\nrf6310\s110\ble_app_hids_keyboard
Firt I connect to Android device and keep one whitelist.pp_addrs and one whitelist...
Hi,
Parameter uint8_t ble_gap_scan_params_t::filter is present in the documentation, but not implemented.
Checked for SDK 5.2.0 and 6.0.0.
devzone.nordicsemi.com...
After I get a Disconnected() event, I want to start scanning again, therefore try to call StartDeviceDiscovery() again.
IsDeviceDiscoveryOngoing was checked before.
The...
Hi,
I'm trying to get latch functionality working on two GPIO pins, but cannot seem get the latch register to behave consistently.
I have my GPIOs configured using a custom...
Hello All,
I have following question
What is the Bluetooth SIG Host Sub System QDID of the chip nRF52832 with software: Nordic SDK version 8.24.1 and nRF Softdevice...
Dear Support team,
I am using the NFC Tag of the nRF52840, CKAA F.
What is the maximum rating of voltage and current of the NFC Tag?
-> I set NFCPINS.PROTECT = NFC which...
Hi!
What is the easiest way to compare two sdk_config files? Some tools, etc. Why do I need it:
My idea is to use "$NRF_SDK/config/nrf52840/config/sdk_config.h" as base...
Hi. Currently I am been getting NRF_ERROR_NO_MEM on nrf_sdh.c:391. I am using the nrf5 SDK 17.0.2 and the nrf5 SDK for Mesh, working primarily on the nrf52840 DK.
So currently...
Hello,
Is it possible to use the CONFIG_MPSL_FEM_NRF21540_TX_GAIN_DB config option on the app core only? Meaning if I have a proprietary controller, is there a way to adjust...
Hi Team,
I am working on NRF52832 based on the BLE mesh protocol here I am using the Light_switch example of SDK - nrf5sdkformeshv500src
Here I need to send the message...
I am connecting to the ble device from the PC through pc-ble-driver-js .
There, I am using the nrf52840 dongle with Connectivity firmware, and the wireless performance of...
good day,
is it possible to change the assigned DFU button (Button4) to other button or gpio in the secure bootloader example? if yes, where do i need to do it?
thank...
Hi,
I want to use the functions app_uart_get() and app_uart_put() to communicate between the computer and NRF52840.
But when I type a string on the computer, the app_uart_get...
As I found inconsistent information about it, I would like to clarify this:
Is the nRF52840 compatible to both Bluetooth Classic as well as Bluetooth Low Energy?
Would...
Hi,
I have a nRF5340-DK with a ATSAM3U2CA interface MCU as an on-board debugger.
For the nRF52840-DK, the interface MCU firmware is available to download: https://www...
