Hi,
I use UART bootloader SDK example(dfu_dual_bank_hci) to do update firmware on EK PCA10001 board,it can work ok.But i changed the HCI_SLIP_UART_RX_PIN_NUMBER and HCI_SLIP_UART_TX_PIN_NUMBER...
Hi. I have been trying get a notification through ANCS.
I have created an app which is made by modifying ble_app_ancs sample.
It works basically but there is one problem...
Hello,
I'm using the nrf51422 with 210 softdevice.
I'm trying to figure out a way for the receiving slave device to go to sleep when away from the master, but to wake...
To be able to upgrade FW through UART, a bootloader for nrf51822 is required in my project. I have tried out the example bootloader in SDK. But this example is using softdevice...
I followed the forum posts and nan-29 to get eclipse 4.3.2 to successfully connect to JLinkGDBServer via a Segger J-Link EDU on Ubuntu Linux.
I can start the GDB server...
I'm using Softedevice 6.0.0 and SDK 5.2. and Keil 4.7.
I Modified bootloader project so it compiles with both ble and hci transports. Currently I use button_0 and button_1...
I am working on the proj that needed 2 MCU and nrf51822 work as slave.
I would like to know any ref on how to firmware upgrade on board without external tool?
I want to achieve: 1. Mobile application networking with multi-lamp mesh 2. After mesh networking, many smartphones control all lights independently through proxy nodes. I...
Hi,
We are using nRF52832 based module on which we are using HCI over UART functionality with the help of Zephyr(v1.14.0) SDK to find the nearby beacons via Bluez stack...
Hello there,
So we are working with a sensor that needs to receive a pulsed voltage, so we are using a PWM signal from our nrf51-DK applied to a transistor based circuit...
I want to be able to read the gyro and accelerometer values from the MPU6050 sensor.
As a base start I downloaded the nRF5 SDK v15.3.0 and modified twi_sensor_pca10056 program...
Dear support,
We have built a ble mesh network running the light_switch_client/server application (mesh sdk 3.1.0). We are using the Android application for provisioning...
I want to disable and enable interrupts for Rx data, I tried following code to disable interrupt for rx and disable rx. Also TX and RX pins are short, i.e. loopbacked. In...
Hi,
I was wondering if I could get some guidance (or directed to some documentation on the subject) with regards to what socket operations are safe to do in a-sync timer...
I'm trying to use LTE and GPS in the same project. I know I cannot have LTE and GPS running concurrently, but I tried implementing edrx so I could get a GPS fix and alter...
Hello!
I bought recently some nRF52840 (PCA10059) dongle's and one nRF52840- DK. I want to create a kind of network ( a mesh network) from those dongles and communicate...
I cannot see CRASHLOG with RTT viewer but can see CRASHLOG dumps when SES ide debugger is running.
Is there anything different from the SES ide debugger's dumb terminal...
Hi I am working on modify proxy client switch example from mesh sdk version 2.i done some significant changes into code for sending string message rather than 1 or 0.but when...
HI,
AT command not working when network mode is "NB-IoT" in "mqtt_simple",
If network mode is "LTE-M" then AT command is working fine.
Snapshot with network mode is...
