Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
We just recently started testing with slave latency above 0 to save power. Our connection interval is 60. If we have a slave latency above 3, then the connection terminates...
Hello,
I want to calculate RSSI using TX power(Measured power at 1m) and instant RSSI getting in NRF CONNECT APP and Environmental factor.
I have used this
Distance...
I want to debug my adafruit feather nrf52840 sense with my nRf52840dk I followed this link: FAQs | Bluefruit nRF52 Feather Learning Guide | Adafruit Learning System
But...
Hi,
I am having a connectivity problem with a central Bluetooth device (nrf52832) that has to be connected to a peripheral (nrf52840), previously this connectivity worked...
I had a simple blinky application. With this application running I was able to flash a new version in the nRF52480 SDK board at address 0x0086000 with JFLASH. Pressing button...
Hi,
When sending a command using Zigbee, I understand the best method to use is by using:
So when calling light_switch_send_step, I use:
Which in turn calls below...
I'm trying to connect a nRF52832 DK to a secondary device (BLUETOOTH LOW ENERGY TINYSHIELD (ST)) where the nRF is the central. The example correctly connects to the board...
Hi,
I aw various other posts ( )
and the post on Optimizing power on nRF53 designs but I never get results that low.
The Blog post doesn't really help, since it only...
Hello People,
I was working on the example program of timer (PCA10056) and it was working fine, but when I change the same code to work on PCA10100 it is not showing any...
Hi,
I have integrated HID mouse and keyboard, when my custom board was connected with computer, there is "hello" on notepad. But when I pushed "CapsLk" key, RTT viewer did...
Hello.
I try to add my own board to Zephyr. I made copy/paste nrf52833dk_nrf52833 and change file names and keywords. New folder is in: "C:/ncs/zephyr/boards/arm" . Unforunatelly...
Hi,
With reference to the below image:
As you can see I have 2 UART threads running on priorities 14, at baud 115200, which are I believe blocking the MPSL signal...
In order to get some more insights in energy consuming "network searches", I tried to keep track of the LTE_LC_NW_REG_SEARCHING and LTE_LC_MODEM_EVT_SEARCH_DONE events.
...
