Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hi,
My project is set up as out-of-tree using NCS v2.0.0. I would like to restrict the NCS version such that it will throw a compile-time error if a non-matching version...
I am using SDK v16.0.0 with s140 softdevice. In app_util.h, there is STATIC_ASSERT_SIMPLE and STATIC_ASSERT_MSG definition decided by platform like __CC_ARM or __GNUC__. ...
Dear Nordic fellows,
I have a NRF52832 and I want to configure the UARTE peripheral driver in not blocking mode. I want to try and exploit the double buffered DMA. I'm using...
I am using UART to try to send and receive data from the MCU on my nRF9160 board. I noticed in the tutorial on DevAcademy that using the asynchrounous mode, we're able to...
Hi！
Due to product requirements, I need to make the broadcast package contain 128-bit UUID so that the APP of our company can identify the device. The chips of other manufacturers...
Hi
I am using NRF5340 chip in my custom designed board and I want to use all the 4 UARTs available in this chip at the same time.
The interesting problem which I am confronting...
nRF52840, nRF Connect
I was looking at the button example and it is apparently a little different then in the nRF5 SDK kit. In the SDK you had a callback and inside that...
Hi!
For a custom project, I need to enable and disable soft device on a peripheral. I'm able to enable/disable softdevice for two cycles, then I get this error:
<error...
Hi,
I'm trying to mount two spi flash device on spi0, but can't found the second one(device_get_binding() return NULL).
The two device has compatible ("jedec,spi-nor"...
Hello Support,
In my project I use the nrf52840 with the nRF Connect SDK to create a OpenThread device with an Secure MQTT connection to a broker.
I've got the OpenThread...
Hi. I am trying to output a square wave on to separate output pins. I want to have one inverted, however I can't even get the same output on both pins at the moment. The pin...
I want to use HCI_USB on nRF52840 board(nrf connect SDK).
Legacy Advertising Scan is success.
But,, I don't know how to recieve the Extended Advertising Scan.
Please...
