Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hi,
Can u suggest the procedure to implement key refresh procedure with reference to the API present in nrf SDK as per the standard procedure defined in Mesh Profile Spec...
Hi community,
I have recently purchased the DK and have started developing my application. What I wish for it to to is able to change between connectable and non-connectable...
I've just got started with nRF Connect and used the desktop app to install SES and the SDK v1.5.0.
I am trying to evaluate NRF52805 using an nRF52-DK board, so I selected...
Hi
Good Day!!
Im using keil ide While compile the code for crypto aes getting error could no be solved, plz give the solutions for this issue
.\_build\nrf52840_xxaa...
To the kind attention of Nordic support team,
I m developping for a nRF52833 device using two different versions of custom boards. According to antenna measurements and...
Hi,
when I build a firmware with TF-M enabled the device gets stuck after a ca ll to sys_reboot(...) no matter if I use the shell or call the function somewhere else in...
Hi,
I am using SDK_15.2.0 and softdevice S140_v6_1_1.
Host communicate with 52840 via USB (CDC UART). Doing firmware update with proprietary message format.
Stored...
When checking the secure_dfu code, I found the following two code fragments seemed problematic in nrf_bootloader_fw_activation.c
1. In the following one, if the ACTIVATION_ERROR...
Hi, unfortunately, I do not have enough experience with nRF52. Could you please tell me what should I do for scanning the nRF board on the BLE scanner app? The app can find...
I am using a thingy:91 device. I am basically just attempting to write a method that will just wait for a certain amount of seconds (ie: 10 or longer). This is my code below...
I developed the project based on ble_app_uart sample in SDK10.0.0（nrf51822）, Now I need to make factory production tools for the machine.The tool now needs the ability to...
Hi,
Quick questions about the Nrf52832 that I couldn't locate in the datasheet.
1) Does the nReset pin have an internal pull-up? If so, what is the value?
2) does...
SDK 14.2, SoftDevice 140, NRF52840.
My code is below. I am putting stuff on a queue (q1 in the code below) inside an interrupt. This stuff is then processed in the main...
On macOS, in nRF Connect Toolchain Manager, if you open a terminal for an SDK version then $PATH will not contain /usr/local/bin. nRF Command Line Tools installs nrfjprog...
