Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
hello, I want an example that support both Bluetooth Low Energy and 2.4 GHz proprietary , when the BLE is free, it can send with 2.4 GHz proprietary
where can I get this...
Hello, community.
I wonder Bluetooth 5.0 on nRF528xx can be used for file transfer. Bluetooth 5.0 has maximum 2Mbps, I expect that there is no problem to tranfer files such...
Hi all,
I am not sure if I am on the right track by comparing CryptoCell & Optiga TrustX Platform but I couldn't understand the difference exactly. What I understand is...
I am working on developing a UART driver. I am looking for APIs that support this. I see 3 sets of implementation examples:
1. nrf_serial
2. nrf_drv_uart
3. nrfx_uart...
Hello everyone,
I need to take a complete NRF52832 project with code written without the help of an IDE (using GCC and a hand-made Linker script) and make it available...
Hello,
After decided and tried porting nrf_esb from the example code to my project, now I am stuck with changing the content of the payload.
I changed the payload using...
hi, nordic engineers Now I am using the meshSDKv3.1.0 ,nrf52832 . When i test the mesh serial module , it seems not so good, is it a problem? reference to the documents ,...
Hi there
I am currently trying to retain the RAM that is being used by the Softdevice. More precisely the attribute table so that its content does not need to be set after...
i am trying to connect multi peripherals to single "central" and i am using nrf52832 as central, I am using multi link central example for multiple connections but i am not...
Hi!
I am in the process of creating firmware for a product based in nRF52 because the firmware that comes with it does not fit my needs. So I am in the begining of the process...
Hi, I'm new with the Nordic, looks fin but I can't find application command interface description for the PC_BLE_Driver.
Background: I have a running application supporting...
SDK 12.3
nrf51 DK
ARMGCC
Windows 10
I'm trying to switch to gcc. I use 4.9 2015q3 version as recommended.
I have a trouble with simple blank blinky project (nRF5_SDK_12...
Hi,
I update the nRF Connect SDK to the latest version.
I switch SW5 to NRF91 and then erase the flash in nrf91 by using command nrfjprog –eraseall.
Then I use SES...
Hello All,
I am working on nRF51822. I am use IAR and nRF51 SDK 12.3.0.
I want to simultaneously read the value from 2 analog pins. For this, do I create just one adc_init...
