Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello, I'm practicing this blog; Segger Embedded Studio - A Cross Platform IDE
on the following environment.
64-bit Windows 10 desktop
SEGGER J-Link 6...
Hi,
Recently we upgraded from NRF52832 to NRF52840, and as the Development seems to come to an end, one of the last features we need is OTA capability.
currently I am...
Using SDK 15.3.0 and S140 v6.1.1, would it be feasible at all to synchronize two nRF52840 modules, each only radiating in an oposite direction, in such a way they would alternate...
Hello
I am using Android and BLE communication with nRF52832 (BLENano2) now.
I am using SDK 15.0.0 with keil uversion.
Central is Android and peripheral is nRF52832...
Dear Sir/Madam,
I have interfaced NRF24l01 module with LPC1768. Then used example code from Github for Intial configuration of NRF24l01 using LPC1768. checked waveform on...
Hello,
I have a problem with ble_peripheral examples.
Im using Embedded Studio V3.40 and I setup it like in this tutorial: devzone.nordicsemi.com/.../segger-embedded...
I just installed SES v4.16 and get the license key to activated, and also I get nrf5 SDK15.3.0 to test
I open example solution "ble_app_cts_c" and try to build it
result...
Hi,
I tried to find info on how to print float values in Segger windows application, no luck. Of course my question is how do i printf() float values on debug terminal in...
Hi,
Am working on serialization where we have already developed code using nRF5 SDK v11.0.0 but now we started to use nRF5 SDK v15.2.0 SDK.
My problem is am getting...
Hello,
I have a uint16_t variable. It can increment till 16K. After every increment I want to store into Flash, so that even if there is a reset, I can restore the value...
Hello everyone,
I had that problem before and now I have that problem with another V0.9.2 board. I have started IAR and it asked me to update to firmware on PCA10056 so...
I have two mic , how can I get data from Left and Right mic? Is there any example code to help me?
My code like this : ( I think the data from pdm_data_handler is like 0xFFFFxxxx...
