Hello Team,
Could you please share some sample application or procedure to handle power modes (Sleep, Deep Sleep, etc) of the nrf9160.
Please let me know.
Regards, ...
Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hey, I am trying to get a bluetooth mesh up and running with the nrf52832 dev boards (PCA10040) acting as nodes and a Raspberry Pi 3 (with bluez meshctl) as the provisioner...
The implementation in generic_dtt_server.c doesn't properly validate the set message parameter and generates a response despite the message should be ignored.
The Mesh Model...
NRF52 devices and Softdevice 132:
According to SoftDevice specification v5.1 Table 4: Peripheral protection and usage by SoftDevice NRF_FICR data such as ->INFO.PART, DEVICEID...
Hello guys,
everything worked fine for me (NRFConnect, Apps, CLI, Building with Segger Studio, Prgramming via NRFConnect Programmer, everything on Win10) but then I was...
Hi,
I am using nRF52832 DK for testing beaconing and TWIM and TWIS. I am using SDK 14.2.0 S132 v5.1.0.
But, the final product would be using nRF52810. So, will the code...
I'm working on a project with nrf52840 and i'm trying to send and receive ipv6 packet throw thread protocol so i tried to use to send with otIp6Send and receive with otIp6SetReceiveCallback...
Hi,
Is there a detailed analogue circuit model available for the GPIO pins on nRF52. Most of all, I am interested in the circuit model (or SPICE model) for the IO pin when...
Hi, I am currently working on calculating a Li-ion battery;s remaining capacity. As far as I know, I should read the raw value via SAADC. then convert the value back to voltage...
Hello, everybody
I got a problem that i add device name and advertising my specific data according to Beacon example in SDK 15.2.0, but the data order is not what i expected...
Hi，
DMX512 protocol is USITT（United States Institute for Theater Technology）Prescribed agreement
I want to follow this agreement to design
============ DMX512 protocol...
Working on nRF51822 QFAB custom board.
I loaded nRF51822 Beacon v1.1.1 Precompiled hex file in custom board.
Keil 5 Uvision iDE
Windows 7
But I loaded examples programs...
Hello,
I'm developing a solution based on nrf52832 that must be maintained for many years. I want to update my application but also softdevice.
I managed to implement...
Hi,
We are using nRF52832,want to configure non standard baud rate 5787 as per our client request,
Is there formula to calculate the error and reg values please advice...
