Hi! Could you clarify a bit about Bluetooth mesh gateways' implementations. I wonder to know possible ways of Bluetooth mesh gateway implementations. How is it possible right...
Hi everyone.
I catch a terrible issue
When I use nrf52840 and NUS Android app and had for a short time a bad rssi (because of long distance between Android and SoC) and...
Hello
We need to scan for more than 8 devices, so we can't use witelist directly.
We have an idea to use presaved IRK and mac-addresses and use scanning without witelist...
Dear Nordic,
Do we have ready-to-use keyboard driver with scanning/debouncing?
I've not found an example or docs about using KSCAN with gpio-connected keyboard...
Dear Nordic Experts, This one's a tough nut to crack:
The firmware is based on nRF5 SDK for Mesh 5.0.0 with nRF5 SDK 17.0.2 and Softdevice s132 7.3.0. It runs on a nRF52832...
I saw this tutorial:
nRF51 current consumption guide
It's specifically directed to the nRF51, but I guess the principles of Tuning Advertising parameters must be general...
i'm looking to use only one timer for two independent activities:
battery service (as in Nordic examples) and
a routine to detect a certain button press pattern ...
Hi everybody.
I am makeing a custom circuit for nrf51822 CEAA. This circuit supports ANCS and DFU (nrf sdk 9.0.0). I use only external high frequency (16MHz) oscillator...
Forgive me if there is an obvious answer to this; thanks for your patience.
I'm a long time developer but new to the area of BT in general. After a day or so starting with...
Rudimentary question about DFU; thanks for your patience.
I'm developing an app for a "headless" (no buttons, no led's) ble application which will have a companion mobile...
I am trying to get the pstorage module to work with our application and FreeRTOS. At the moment I keep crashing on port_cmsis::prvTaskExitError().
The pstorage documentation...
Hi,
Nordic Community and Developers,
I am trying to measure current on my custom Development board.....But I found out that it is consuming too much current on the chip...
Hello,
I am writing here because I am trying to change some concrete values from a .hex file in order to vary some BLE and other values. I need this because I need to generate...
Hi,
I am trying to compile & run ANSC example under SDK8 in a PCA10001 board. I have programmed the SoftDevice using nRF Go Studio.
Here is the example,
nRF51_SDK_8.0...
In the nRF51 SDK startup code, in the folder toolchain\gcc, there is a file called gcc_startup_nrf51. s . I think this file should be called gcc_startup_nrf51. sx instead...
Hello,I have a problem with data throughput. I use S120 for client and S110 for server.
I set connection interval to 7.5( min connection interval and max connection interval...
Hi all.
I am new to BLE and the nrf52 chip.
What I would like to do is use the device as a beacon, and also being able to connect to the beacon from both iPhone and Android...
