Hello
We need to scan for more than 8 devices, so we can't use witelist directly.
We have an idea to use presaved IRK and mac-addresses and use scanning without witelist...
Dear Nordic,
Do we have ready-to-use keyboard driver with scanning/debouncing?
I've not found an example or docs about using KSCAN with gpio-connected keyboard...
Dear Nordic Experts, This one's a tough nut to crack:
The firmware is based on nRF5 SDK for Mesh 5.0.0 with nRF5 SDK 17.0.2 and Softdevice s132 7.3.0. It runs on a nRF52832...
SoC: nRF5340 SDK: nRF Connect SDK 1.9.1
CMAC calculation works fine with SDK 1.7 and SDK 1.8. But it failed with SDK 1.9.1.
psa_mac_sign_setup returns error = PSA_ERROR_NOT_PERMITTED...
Can I calculated elapsed time from one event using TIMER1?
If yes,how?I can not find none register which one to read for get counter value(how many ticks have passed since...
Hello, I follow
this page to start the rpi2 for 6lowpan.
when I tried to run RADVD Daemon as follow:
Set IPv6 forwarding (must be present).
sudo echo 1 > /proc...
Hello!
I recently purchased a RedBearLab nRF51822 board where I want to use several DS1820 temperature sensors.
For dealing with the OneWire (1-wire) protocol I found...
Hello,
I'm not sure if this was already asked before. I didn’t found a similar question, so here it is: When I have a function that manipulates a data structure to communicate...
In this ADC example from Nordic on GitHub, it does not appear an AIN has been selected (e.g.: no call to nrf_adc_input_select() ). I don't understand. I have been assuming...
Hi,
I am creating a central application on a Nordic nRF51 device. Our project is related to connecting to peripheral of any profile. Using the MCP I connect, bond and enable...
Hello,
For our application I have to set up two simultaneous connections between a S120 master device and two peripherals that use the S110 softdevice.
A very short connect...
Trying to send 3 20-byte packets of data from nRF51822 (peripheral device) to a Samsung Galaxy S5 (central device) and send 1 20-byte packet back, all in less than 10ms. I...
Hello,
I'm looking to bootloader sources and i want to add a timeout if entering with a signal in DFU mode and no DFU detected for one hour.
There is a timers_init function...
I have a project that requires full-duplex voice comms (doesn't need to be high-quality). I'm evaluating the suitability of BTLE for the task. The new nRF52 has a PDM module...
I'm moving to Nordic from "another" BLE s.o.c. where the UUIDs, profiles, services and characteristics were defined in XML. With that product I could modify or examine or...
