Hi Team,
Is it possible to implement the iOS application to track the iBeacon Component after closing the application(Background processing).
Please provide any example...
Hi Team,
To implement iBeacon what are the things to be take care at the peripheral side.
Whether the code for advertising the peripheral in "CoreBluetooth" and "CoreLocation...
Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
Hello,
I want to install NCS 2.1.0, but I get the following problem.
I used toolchain manager 1.2.0 to install NCS 2.1.0. Open VS Code is now available.
I opened...
Hi,
I have a question, I use a 52840 board as the Bluetooth center. The protocol is S140. The other 51822 board is a Bluetooth peripheral. The protocol is S130. The routine...
Hi! We are trying to understand how UICR registers work. In particular APPROTECT, ERASEPROTECT, and SECUREAPROTECT.
We are trying to find a clear explanation for this image...
Hi ..i'm using nRF52832 interfacing with BG95(QUECTEL) ..when i insert my sim in the module at the time uart receiver is not working..when i remove the sim at the time uart...
hello
iam trying to add services in the buttonless dfu from one of the sample code im not able to come up with the services after lot of efforts and now im getting this...
Hi There,
I would like to extend the NRF9160 LED CAF by using the WS2812 LED instead of 3x discrete LEDs.
1. Where in the CAF or Zephyr or wherever, are the function calls...
Hi, We are trying to work with nrfxlib directly baremetal without Zephyr. Were able to do advertising with it. On nRF52832 the SDC crashes when we tried to set new advertising...
Dear all,
I am developing a bluetooth mesh sensor with the NRF52833 and NRF Connect SDK.
The sensor is battery powered. So the power consumtion must be as low as posible...
nRF52840, SDK17.1.0 SD140
I am attempting to write a 16 byte array to NVM. This array is initialized simply as uint8_t diaper_aes_enc_key[16];. For testing/learning of the...
Hi,
We have an application which can communicate with a mobile device as a peripheral running on the nrf5340 processor. When a peripheral connection is initially established...
Hey everyone!
I'm getting to know the Rest APIs from nRFCloud.
I'm trying to get the latest location for a set of devices. It seems I have to either get from all devices...
In NCS 2.1 with MCUboot on a nRF5340, a huge 256k area is allocated into .bss (see below) called "mock_flash".
unfortunately this writes far enough into RAM that it overwrites...
