Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hello,
I want to typecast an array of values from short to float. I am doing the below to do that
but when I am doing that, I am not able to get the float value as it...
Hello Developers,
I am facing a issue to connect my nrf9160dk as a lwm2m client in the test coiote iot device management server.
I am following the official documentation...
I'm encountering an issue where the softdevice crashes with only a couple of timers running and a main loop that feeds the watchdog. If I enable more of the code I've written...
Hi,
We want test nRF52833 support on long range. I referred https://github.com/NordicPlayground/nRF52-ble-long-range-demo .
So as first step we use nRF52840 dongle for...
I am using NRF52833 in my project and I have my NRF module connected to 2 other microcontrollers on UART peripherals. The details are mentioned as below:-
1) NRF52833 connected...
Hello,
I am trying to develop a driver for the temperature ADC controller ADS124S08 https://www.ti.com/product/ADS124S08 .
I have modified the EVM to work with an external...
I'm working on the nrf5340 with a modified sample found here ( main.c of the base sample here ) and nrf connect sdk 1.7.1
I see that adc_sequence_options .interval_us can...
I need to calculate the power consumption of a device. For this I purchased PPK2.
I use nRF52-DK for tests (there is the same microcontroller as we need).
The accelerometer...
Hi,
I am trying to utilise the available thread examples to build comms from CoAP server to external website through Border Router.
I have configured Border Router as...
Hi There,
I am presently running a BLE peripheral example on a custom board with SD Card data logging functionality, The SD Card library has worked fine until now , Since...
How to print a float value in segger embedded studio?
I am using nrf5_sdk17.1.0 version
I have used the below statement but it is outputting 0 only always.
NRF_LOG_INFO...
Hi,
I am using nrf52832 for a battery powered PIR sensor. I want the device to be awake only when in it detects motion. Can anyone guide me to use the lpn example in the...
