Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I have the NRF5340-DK development kit to calculate AOA. However, I need an antenna to do this. Do I have this antenna in Nordic or can I find a compatible antenna. How can...
Dear Members,
I want to use libuarte with ANT and softdevice,
When I initialize libuarte,
The app keeps restarting by itself.
I commented out
//err_code=nrf_drv_clock_init...
I have seen that some other ppl had a similar problem, but I couldn't figure out in the posts how to resolve the error in the title.
The issue is following: I have to use...
How can I display the beacon signals receiving from nordic thingy 52 at my device? Please suggest if I can display the same using UART data and if yes then how to display...
I am attempting to install the nRF Connect SDK on my CentOS 8 machine. It looked like it installed correctly, but when I attempt to load the zephyr sample "Hello World" in...
Hi,
I'm trying to build the bluetooth/peripheral_uart sample in NCS (version 1.5.0-rc1) and was surprised to see that it requires more than the 24K SRAM available on the...
I'm evaluating the nRF5340 for a small-scale initial project at first. We want to use Bluetooth LE (long range). We don't want the hassle and expense of Bluetooth certification...
Note: I am currently using version 2.4.2 of the BLE Desktop application and the NRF52832.
I'm working a peripheral device that has about 800 uC of energy that can be stored...
I've been using west build and SES open for projects that only use the app processor without issue. However, I'm not trying them with a project using both the app and network...
Hi, all
I'm using nRF52840, pca10056.
I have a question about the rtc example of peripheral.
I want to know the difference between 'nrf_drv_rtc_init' and 'nrf_drv_rtc_cc_set...
Dear Concern,
I am working on nRF52832 DK board. As per product specification document, nRF52832 support CCM — AES CCM mode encryption . I need to work on AES CCM mode encryption...
I am searching for a straight answer to this question. 'Application event' is used frequently in the documentation but never defined. I write the application but I clearly...
I use nRF52832 as a central device. I also use ble_app_uart_c as a SDK(17.0.2) . I would like to connect my peripheral which is my phone(iPhone 6) and i want to see my phone...
