Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
Hello,
I previously used the latest SDK v17.0 on my nRF52832 PCA10040 board DK.
I ran the ble_app_uart example in order to understand how the Nordic UART Service works...
Hi all
I am doing a small personal project. I have 2 DK's :
nrf51 DK: pca10028
nrf52 DK: pca10040
Up until recently things worked fine, but suddenly i ran into a...
1. At present, using the Programmer burnmodem firmware in tool nRF Connect mfw_nrf9160_1.2.0.zip step is cumbersome.
2. Is there a simpler command line tool that can burn...
We have v0.8.2 of the nRF9160DK which has GPS antenna issues. We are looking to get the latest available version of the DK from Mouser/DigiKey. Is there any way to ensure...
Hi,
I want to use SPI to receive data from an ESP32 microcontroller to the nRF52840 development kit. Where can I find information/example regarding the same (I'm using nRF_SDK_17...
Hi
we have a custom board with nrf52810 chip, 32M crystal on it and using the zephyr version 1.14.1 as the firmware base.
Using zephyr samples/bluetooth/hci_uart
Custom...
Hi Sir,
We design the nRF52810 in an embedded system and plans to use BlueZ to control the BLE device.
We can work with nRF52-DK through HCI_UART, so w e also implement...
Hi There
More recently, I have implemented the experimental of nrf52840 Dongle ,which is about Er asing it with nrfjprog or programming it with SES by DK. The dongle will...
Hi. Its my first post here.
I plan to make a secure remote control for garage door opener product with a BLE SoC, for example, currently I plan to use nrf52832. We want...
Hi There
I did 2 experimental for recovering boot-loader of nrf52840 dongle by download dfu (nRF5_SDK_16.0.0_98a08e2\examples\dfu\open_boot-loader\pca10059_usb_debug\ses...
My device is central and peripheral running freertos.
In the central role it would receive advertised packets from devices with certain MAC addresses. peripheral device...
I have a peripheral device that sends an advertisement package with all the data I need every 5 seconds (sensor).
When I use NRF Sniffer via Wireshark I see a message from...
