Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hello. I am developing a project with a static password. And when I connect to the device, in the debug messages for the auth_status field I get the following values: 61,...
Hi ,
I want to add DFU service into ble_app-uart example, for that I want take reference as ble_app_buttonless_dfu.
But when I am trying to test the working of ble_app_button_less_dfu...
I developed an application based on ble_app_uart and it is working on my nRF51 DK. I can see the ports driven by my application responding and Bluetooth communication is working...
I am currently using Mesh SDK 3.1, running on NRF52480 with SoftDevice140. We are currently modifying the light switch client, and would like to know which servers are available...
Hello,
I would like to implement a device that is part of a BLE Mesh Network and on the other side connects to another device directly with BLE Stack (1:1) and GATT.
...
I am developing an android application to get real-time temperature over BLE notification. Currently, I receive the temperature sensing data 1 time per second. Based on the...
Hello,
In nrf_dfu_ble.c BLE_GAP_EVT_SEC_PARAMS_REQUEST pairing on Windows 10, the following code:
err_code = sd_ble_gatts_value_get(m_conn_handle, BLE_UUID_GATT_CHARACTERISTIC_SERVICE_CHANGED...
Hello everyone!
I want to form an Openthread network with three Nordic nRF52840 cardboards. I would like to monitor the traffic using a sniffer, but i can't receive any...
I want to implement the function of periodic temperature collection，but I didn`t find any data show in putty terminal，and I`ve set NRFX_TIMER_ENABLED 1 NRFX_TIMER0_ENABLED...
Hello,
The BLE mesh spec says the following:
Heartbeat is used to monitor nodes on a network and discover how far nodes are apart from each other.
Is there an example...
Hello. I have read a topic about ADC calibration (gain and offset error in 0x10000024) of nRF51822 here but I can't find the document describing it. Could anyone point me...
Hi,
I am beginning to design a wearable device with motor vibration using nRF52 SDK and SoftDevice S132.
In firmware side, I have no problem to control a led on and off...
Hi
in my test bench for system validation I would like to control the system based on nRF52 via Bluetooth to speed up testting of various samples.
It seems that there...
