Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hi,
I would like to obtain printf and NRF_LOG separately from two TX ports.
I made a test application of serial output based on blinky.
P0.06:TX (and P0.08:RX) were...
I'm working on the project where data from nRF52840 need to be send to Android over wire. The customer does not want to use BLE.
I can connect nRF52840-DK development board...
I am first time using Nordic development board 52840. I want transmit zigbee frame from application processor to network processor via UART. Please check below communication...
Hi, i use SDK 15.0.0 ble_app_uart_pca10056_s140 nrf52840
I set BLE parameters like this:
#define MIN_CONN_INTERVAL MSEC_TO_UNITS(7.5, UNIT_1_25_MS)
#define MAX_CONN_INTERVAL...
Hello everyone.
I am trying to use my oled display with my nRF52832. I found a library that had been written before: https://github.com/monpetit/nrf52-spi-i2c-master-ssd1306...
Hello, I am wondering about something related to the numebr of elements. Does the number of elements needs to be fixed or it could also be also dynamicaly changed? Also, regarding...
hi..... i am using nrf52832 , merged the uart and timer example program . while i am debugging , debugged successfully , but timer is not working
actually i set the timer...
Hi,
I am developing a product based on nRF52840 chip. I want to know if there are any bootloader available for nRF52840 which has following capabilities:
1- The bootloader...
Hi,
I have set up nRF9160 DK by following instructions here: https://www.nordicsemi.com/Software-and-Tools/Development-Kits/nRF9160-DK/GetStarted#infotabs
By using nRF...
Dear nordic,
I have some doubts in BLE profiles.
1. If i started make custom profile as per your examples is that make any issue in BLE certification of product?
2.If...
I have an issue with the internal clock setting, and TWI. My custom board has an issue with the external crystal. So I switched to internal crystal with the following settings...
