I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I've recently began experimenting with the HID service and connecting to iOS devices in order to achieve lower connection intervals with Apple products (as described in their...
Hi
I have a question about using gazell link layer and paring library with concurrent timeslot api. I try to do this but i have the hard fault handler after invoked nrf_gzll_init...
HI,
I want to use PWM to control various hardware (LED's, etc ..) so I started off from the suggested PWM code example, found in this forum + modified it as I want to use...
hello,
the function ble_stack_init () in the example of ble_app_uart are quite different from that in the example of ble_app_proximity in my first sight.
ble_app_uart :...
Hi, I am using S112, nRF52832 and SDK SDK_17.1.0_ddde560.
Using below code snippet I am putting device to deepsleep. I have turned off the RAM retention. However, still...
I am trying to create Docker image with all the tools to build and flash the board. But I have the problem with nrfjprog:
$ nrfjprog bash: nrfjprog: command not found
...
Hello Nordic Team, We haven chosen a nRF52805 SoC and MDBT42T Module and would like to operate with 2 i2C sensors on two different Pin-pairs. Since the nRF52805 only has one...
Here's what i am struggling with: my code generates a error while building for every line where i use a function starting with "nrf_drv_gpio_..." saying there is an undefined...
Hi all,
I am about to purchase NRF51-DK Nordic Semiconductor ASA | Development Boards, Kits, Programmers | DigiKey but this says for nRF51422, nRF51822 series Transceiver;...
Hello,
I am using the peripheral uart sample and it works fine. My issue is that whenever the buffer is full it automatically sends the data from the com. How do I stop...
I'm working on the nRF5340 using the newest release of the nRF SDK, SoftDevice and zephyr project. I get the connection index from our application but need to retrieve the...
I change nRF52832 firmware to support DFU OTA. But ble_dfu_buttonless_async_svci_init() failed with errCode=0x4.
0> <info> app: Version 1.2.1 0> 0> <info> app: ========...
When I use Keil to build project for supporting DFU OTA. Keil shows changing *.o to *1.o. Is it normal?
Build started: Project: ble_app_band_v4 *** Using Compiler 'V5.06...
We are using the Softdevice controller from the nRF Connect SDK on the nrf5340 processor and have implemented the commands to read and set the tx power level in the controller...
I want to take readings from SHTC3 temperature and humidity sensor from a custom board. Using I2C master as nrf5340 how can I take readings from slave custom board. Please...
