What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I've recently began experimenting with the HID service and connecting to iOS devices in order to achieve lower connection intervals with Apple products (as described in their...
Hi
I have a question about using gazell link layer and paring library with concurrent timeslot api. I try to do this but i have the hard fault handler after invoked nrf_gzll_init...
HI,
I want to use PWM to control various hardware (LED's, etc ..) so I started off from the suggested PWM code example, found in this forum + modified it as I want to use...
Hi, I am trying to use the CAF BLE state module to manage my bluetooth connection.
To understand how it works I have been testing the nRF desktop application, which makes...
I am developing for nRF52832 chip running the latest version of SDK. I'm looking to enhance my application to support 5 simultaneous advertising sets. These are non-connectable...
Hi There,
When I try to run the beaconing example in two broads, if the two all broadcast, they can receive messages from each other; But if one doesn't broadcast, it...
Hi, I am trying to implement a BLE mesh using nrf52840. How can I estimate the current consumption? I checked with the online power profiler tool, but it does not support...
Hello All,
There are several issues where I can see RTT viewer is not working along with nrfjprog tool etc....
I am also facing similar issue where RTT viewer(version...
Hi,
While I can find many discussions about how to set the MAC address using the soft device API with previous SDK's, I cant find a way to change the MAC address of the...
New nRF52-DK PCA10040 2.1.0 2021.24
The out-of-the box "Get Started" procedure where I move my iphone near the antenna did not work (did not pop up any web page). NFC was...
Hi,
I'm leveraging the ble_app_cli example program for my project. The primary reason for this is that I need BLE and I need to be able store and retrieve log data which...
I'm downloading a firmware image from AWS via cell onto the nRF9160. I want to perform a serial DFU over UART. The DFU target is the nRF52840. Are there any existing samples...
Hello DevZone,
I want to send a simple AT-Command like: AT\r\n from the ESP32 to the Fanstel BC805M (nRF52805M) breakout board.
Problem : The Esp32 does not get a...
When handling a `BLE_GATTS_EVT_WRITE` from a queued write, the write event has the characteristic handle set to zero. How can I identify what characteristic is being written...
Hey there!
I'm new in the development with the nrf9160dk. And I wanted to connect the Murata SCL3300 digital inclinometer to the development kit via the SPI lines. However...
