Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hi,
I based a new device design on the Thingy91 antenna and tuning circuitry and noticing that the current consumption of the two QM12038's negates the amazing power efficiency...
1.In docs I see: “This example requires one of the following SoftDevices: S112, S132, S140”. What is the reason not to support S113?
2.Is there a way to accomplish functionality...
The Cloud_client sample application does not work in this version.
The connection with the nRF Cloud is disconnected immediately:
I: Network registration status: Connected...
Hi, I am trying to add a secure button less OTA service in my application.
1-I have successfully added service but showing the following error.(I can see OTA service in...
Hi,
We have been working with a Zigbee coordinator based on nRF52840 with nRF5_SDK_for_Thread_and_Zigbee_v4.0.0_dc7186b, Softdevice and FreeRTOS.
Zigbee task defines a...
Hi,
Is it possible to add a custom characteristic to a standard BLE service? I wish to add a CO monitor with ESS (0x 181A ). If yes, how to add a 128 bit UUID with this...
Hello,
I want to output in one pin 400kHz and inverse of 400kHz in the other pin. I have somehow managed to output the the 400kHz but haven't managed to output its inverse...
I'm trying to implement advertising only on a single channel
Here is my initiation function
but ble_advertising_init is returning err_code 0x00000006
I believe it...
Hi everyone,
I have come across the FPU_FFT example project for nRF52840. Just for curiosity - I'm HW-guy - I'd like to evaluate FPU's performance - to see how many instructions...
Hi,all:
since I add USBD in ESB example,when compiling and linking,I make error as nfr_queue dose not fit UNPLACE_SECTION, overflow 20 bytes. I take the line statement about...
I have a requirement to collect data over a plant, say a power plant whose size may be 3 KM by 3KM. I am planning to have a Bluetooth mesh and collect data and control equipments...
Hi,
We currently have a regular SIM, and it works well except for the inability have very low power draw when the device is in low power states. Based on our testing, we...
Hello,
I want to learn how we generate the frequency on nrf52832. I simply take a Blinky led example and on that blinking the led. i want 1MHZ frequency . so how should...
