Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hi
I used nRF5_SDK_14.2.0 to develop nRF52832. Now I have a problem. I used the demo of ble_app_blinky in the ble_peripheral files. I want to send the 2552 bytes by ble_lbs_on_button_change...
Dear Sir,
I am implementing a program in which I need to stop advertising inside the function ble_evt_handler() .
I am starting the advertising by calling the function...
Hi everyone, for the project I'm developing it's extremely important to measure RTT as accurately as possible and as such, after some SoftDevice specification I imagined the...
Hi,
I am using Ble_app_gatts central example. Applied filter on name and connection made with some device which is not Nordic BLE device.
As in this central code, after...
Hi All,
I am using Keil and GCC but I want to migrate my projject to "Seggers Embedded Studio for ARM". After following the tutorial about migration, i have been able to...
I've been doing some exercises with the FDS module to ensure I understand it and have come across an issue. When I write I am not seeing a write call-back in the fds_event_handler...
I do not know why the comparator does not compare correctly. I use AIN6 as Vin+; ANI0 as Vin-. The code is show in below. The comparator is work in differential mode.
...
Hello,
I am using the following
Mesh Version : nrf5_SDK_for_Mesh_v2.2.0_src
SDK Version : nRF5_SDK_15.0.0_a53641a
IDE : SEGGER Embedded Studio for ARM Release 4.10...
Just wondering if anyone knows a reliable method to update a project to use a new SOFTDEVICE version?
One that can be repeated for each new release.
I am using Segger...
Hi,
I have a question about pairing a phone with the nrf52832.
During the pairing phase (the phone see our device that is advertising and then starts the paring procedure...
Hello,
i am facing issue with nRF5x Command Line Tools. I am using custom board with nRF52832. While i am using Segger J-flash Lite there is no problem to flash program...
I am developing a wearable using nRF52832 and looking for best debugging practice. I have given provision for SWD pin connection on PCB board. What is the best suitable JLink...
Dear all,
I'm looking if there is a easy way to add custom commands to the OpenThread CLI without touching the OpenThread core ? I didn't find anything in the API.
Thank...
