Hi,
Will PAN item #56 TWI: TWI module lock-up be fixed in the Rev 3 version of the nRF51822/51422?
Also would you happen to have a time frame as to when the Rev 3 will...
Close Bluetooth in Iphone's settings when IOS/51822 is paired and connected normally.
several seconds later, Open Bluetooth in the settings again, and observe the settings...
Hi,
I am trying to power off and/or disable a RR[0] with no success.
I am Powering OFF the watchdog in main and then successfully POWERing ON in wdt_init but then I...
Is it possible when using the S110 softdevice to limit the maximum number of packets per connection event? I would like to reduce the maximum amount of time the CPU spends...
I am using nRF51422 Evaluation Kit with the latest silicon revision which comes with programmable softdevice. The kit also contains an ANT USB-m dongle. I have followed the...
I tried to do send & receive binary data from bluetooth in ios app.
But i only can send & receive string or ASCII code data in my app, do you have any method or idea can...
Hi,
I tried ble_app_hids_mouse with Android 4.4.2, it can work properly for first time connection. However, it cannot be re-connected after switching Phone's Bluetooth...
Hi,
I'm trying to get latch functionality working on two GPIO pins, but cannot seem get the latch register to behave consistently.
I have my GPIOs configured using a custom...
Hello All,
I have following question
What is the Bluetooth SIG Host Sub System QDID of the chip nRF52832 with software: Nordic SDK version 8.24.1 and nRF Softdevice...
Dear Support team,
I am using the NFC Tag of the nRF52840, CKAA F.
What is the maximum rating of voltage and current of the NFC Tag?
-> I set NFCPINS.PROTECT = NFC which...
Hi!
What is the easiest way to compare two sdk_config files? Some tools, etc. Why do I need it:
My idea is to use "$NRF_SDK/config/nrf52840/config/sdk_config.h" as base...
Hi. Currently I am been getting NRF_ERROR_NO_MEM on nrf_sdh.c:391. I am using the nrf5 SDK 17.0.2 and the nrf5 SDK for Mesh, working primarily on the nrf52840 DK.
So currently...
Hello,
Is it possible to use the CONFIG_MPSL_FEM_NRF21540_TX_GAIN_DB config option on the app core only? Meaning if I have a proprietary controller, is there a way to adjust...
Hi Team,
I am working on NRF52832 based on the BLE mesh protocol here I am using the Light_switch example of SDK - nrf5sdkformeshv500src
Here I need to send the message...
I am connecting to the ble device from the PC through pc-ble-driver-js .
There, I am using the nrf52840 dongle with Connectivity firmware, and the wireless performance of...
good day,
is it possible to change the assigned DFU button (Button4) to other button or gpio in the secure bootloader example? if yes, where do i need to do it?
thank...
Hi,
I want to use the functions app_uart_get() and app_uart_put() to communicate between the computer and NRF52840.
But when I type a string on the computer, the app_uart_get...
As I found inconsistent information about it, I would like to clarify this:
Is the nRF52840 compatible to both Bluetooth Classic as well as Bluetooth Low Energy?
Would...
Hi,
I have a nRF5340-DK with a ATSAM3U2CA interface MCU as an on-board debugger.
For the nRF52840-DK, the interface MCU firmware is available to download: https://www...
