I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I've recently began experimenting with the HID service and connecting to iOS devices in order to achieve lower connection intervals with Apple products (as described in their...
Hi
I have a question about using gazell link layer and paring library with concurrent timeslot api. I try to do this but i have the hard fault handler after invoked nrf_gzll_init...
HI,
I want to use PWM to control various hardware (LED's, etc ..) so I started off from the suggested PWM code example, found in this forum + modified it as I want to use...
hello,
the function ble_stack_init () in the example of ble_app_uart are quite different from that in the example of ble_app_proximity in my first sight.
ble_app_uart :...
What is the maximum value of RSSI parameter for nrf_gzll_device_tx_info_t structure?
I have done a test on RSSI parameter value return in nrf_gzll_device_tx_success callback...
Hi Nordic
I don't fully understand the drive settings for the GPIO. For example S0H1 means when the pin is CLEARED, it will use standard drive (can sink 0.5mA) and when...
Hi there,
i was trying to implement a firmware for a small device using the nRF8001 only in broadcasting mode.
So far, everything works fine. But one thing mentioned...
I'm happy with the status of my app on the evaluation board and I'm ready to start downloading it to my target board. I plugged the Segger J-Link Lite CortexM board into one...
I'm looking into the service creation portion of BLE, and I've made it pretty far. But one problem that I'm running into is sending more than 8 bits of data at a time back...
Now I am doing the BP by using the "ble_app_bps" project. I find it still advertising after connecting to the master,so the power consumption is high.So I wanth to use the...
The nRF8001 provides pipes to the Characteristics on the local GATT Server and the remote GATT server. How is this different from the handles of Attributes.
The setup for the nRF8001 that is generated by the nRFgo studio can be placed in NV-RAM or the RAM of the nRF8001. Is it possible to put a new Setup in the NV-RAM or put in...
We have some profiles that has power saving modes that changes the advertisement parameters while running. We want to change the advertising parameters from the application...
The Master Control Panel uses the PCA10000 board loaded with a ME (Master Emulator?) firmware.
Is it possible to get the source code to this firmware in order to make your...
