Close Bluetooth in Iphone's settings when IOS/51822 is paired and connected normally.
several seconds later, Open Bluetooth in the settings again, and observe the settings...
Hi,
I am trying to power off and/or disable a RR[0] with no success.
I am Powering OFF the watchdog in main and then successfully POWERing ON in wdt_init but then I...
Is it possible when using the S110 softdevice to limit the maximum number of packets per connection event? I would like to reduce the maximum amount of time the CPU spends...
I am using nRF51422 Evaluation Kit with the latest silicon revision which comes with programmable softdevice. The kit also contains an ANT USB-m dongle. I have followed the...
I tried to do send & receive binary data from bluetooth in ios app.
But i only can send & receive string or ASCII code data in my app, do you have any method or idea can...
Hi,
I tried ble_app_hids_mouse with Android 4.4.2, it can work properly for first time connection. However, it cannot be re-connected after switching Phone's Bluetooth...
I have installed Keil MKD-Lite V 5.10.0.0 and the Segger software (which linked to the Keil IDE). I have tried to install the nRF51 SDK (5 times) and every time iI get the...
hi,i am using nrf52 DK kit. i have interfaced it with bmd 101 ecg sensor. The sensor sends continuous data over UART. I am using SEGGER IDE. The code which i am using is ble_app_uart...
Hi there,
I'm confused with the meaning of the 'vloc' variable in the attribute meta data. In the example code ble_bps.c of "ble_app_bps_pca10040_s132" , in the function...
Hello,
We are experiencing an issue that some of the nRF52832 is not starting up automatically. But we attached it with JLINK debugger and didn't do anything, it can boot...
Dear Community,
I'm including a wireless bootloader to enable firmware updates in my application. My question is the following:
Before entering in DFU mode from my app...
Hi,
I am currently facing a coming issue by using the function net_pton. Under MacOS I get the following error:
1> app/libapp.a(main.c.obj): In function `inet_pton'...
I've got this logs while running out of the box the light switch example in zigbee sdk v3.1. I am connecting to a smarthings hub.
<warning> app: Production config is not...
I'm attempting to write a plugin/dll to pull data from the Nordic Thingy52. I can scan all devices that are paired with windows 10, and load up the services, etc.
I can...
Hi,
I am trying to replicate the benchmark numbers stated by Nordic for the nRF52840 to verify I have setup the chip correctly for maximum performance. I have caching turned...
Hi everyone,
I try to send my nRF52 DK board to an android application.
nRF52 example source is "ble_app_blinky_pca10040_s132" and Android app sample is nRF-Blinky from...
Hello everyone,
I am trying to develop a windows application using the same example from pc-ble-driver-4.1.1\examples\heart_rate_collector/main.c. When i call the function...
I am currently working on a project where I try to send data from a swimmer in the open sea to a point on the land (beach). I know that Bluetooth communications are blocked...
Hi,
I am advertising with device name A but if someone holds a mobile to the NFC I would like to switch to NFC OOB pairing but with a different device name B (SDK version...
