Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi,
I'm trying to get latch functionality working on two GPIO pins, but cannot seem get the latch register to behave consistently.
I have my GPIOs configured using a custom...
Hello All,
I have following question
What is the Bluetooth SIG Host Sub System QDID of the chip nRF52832 with software: Nordic SDK version 8.24.1 and nRF Softdevice...
Dear Support team,
I am using the NFC Tag of the nRF52840, CKAA F.
What is the maximum rating of voltage and current of the NFC Tag?
-> I set NFCPINS.PROTECT = NFC which...
Hi!
What is the easiest way to compare two sdk_config files? Some tools, etc. Why do I need it:
My idea is to use "$NRF_SDK/config/nrf52840/config/sdk_config.h" as base...
Hi. Currently I am been getting NRF_ERROR_NO_MEM on nrf_sdh.c:391. I am using the nrf5 SDK 17.0.2 and the nrf5 SDK for Mesh, working primarily on the nrf52840 DK.
So currently...
Hello,
Is it possible to use the CONFIG_MPSL_FEM_NRF21540_TX_GAIN_DB config option on the app core only? Meaning if I have a proprietary controller, is there a way to adjust...
Hi Team,
I am working on NRF52832 based on the BLE mesh protocol here I am using the Light_switch example of SDK - nrf5sdkformeshv500src
Here I need to send the message...
I am connecting to the ble device from the PC through pc-ble-driver-js .
There, I am using the nrf52840 dongle with Connectivity firmware, and the wireless performance of...
good day,
is it possible to change the assigned DFU button (Button4) to other button or gpio in the secure bootloader example? if yes, where do i need to do it?
thank...
Hi,
I want to use the functions app_uart_get() and app_uart_put() to communicate between the computer and NRF52840.
But when I type a string on the computer, the app_uart_get...
As I found inconsistent information about it, I would like to clarify this:
Is the nRF52840 compatible to both Bluetooth Classic as well as Bluetooth Low Energy?
Would...
Hi,
I have a nRF5340-DK with a ATSAM3U2CA interface MCU as an on-board debugger.
For the nRF52840-DK, the interface MCU firmware is available to download: https://www...
