Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
using dongle nrf52840 pca10059 board name.Not able to load the hex file into the programmer app as using the nrf connect for desktop version:3.4.2.Getting the warning...
Hello
I use nrf52832 and SDK v17. And I'm using NUS (UART) service and peer manager. So far, I've been testing with an Android phone and connected it with an iPhone for...
Hi All,
I have modified ARM FB ABI type preprocessor macro to "soft" to optimize power consumption in my saadc routines. But I am seeing below error while compiling. I...
I am developing USB CCID driver class for nordic nRF52840. I used USB CDC-ACM class as reference and tried to implement for USB CCID. I have developed the device descriptor...
Hi,
I have a question of correct way to connect/disconnect/reconnect from the LTE network to save power.
I already know about PSM mode.
But In south korea, SK telecom...
Hello
I'm working on SDK v17, and I'm using the nRF52832 custom board. I use several APP_TIMERs. One of those timers doesn't seem to be working properly. Timer calls are...
I'm just finishing a BLE project for a client. The code is based primarily on examples\ble_central_and_peripheral\experimental\ble_app_att_mtu_throughput. I'm using SDK 15...
Hi there,
We're using NRF52840 and nRF5_SDK_15.3.0_59ac345. We have a product where 2 nRF52840's have to talk to 1 device (say, an iPhone or a computer). We were thinking...
I've noticed when using the nRF Connect Software, after I connect to a perihperal, it immediately discovers services, but takes about 4 seconds to read the GAP Device name...
Hi,
We have been working with a coordinator and a router device based on nRF52840 with nRF5_SDK_for_Thread_and_Zigbee_v4.0.0_dc7186b
Both devices are Zigbee 3.0 and implement...
Hello,
What the average data consumption for using A-GPS on the nRF9160 to download the Almanac and Ephemeris data? I would like to know how much data is billed through...
Hi,
I am developing a product based on SDK v15.3.0 and SoftDevice v6.1.1. my product acts as a BLE central device.
On the peripheral side, is an iOS application which...
Hi,
I need some help in explaining the GPS behaviour I am observing. In the following figures the GPS current draw is depicted.
For the specific scenario the position...
