Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
This question has been asked several times but none of the answers is solving my problem. I am developing a ble application which was loading with no problems. I switched...
Hey,
I neet to change the PHY mode of my connection between nRF52840 DK and OnePlus6 (Android 9) to CODED PHY. If I try to change it, I'm always getting an fatal error and...
An ARM sales rep told me the CryptoCell-310 was discontinued and replaced by CryptoCell-312. Assuming this is true, what encryption module will nRF52840 be using in future...
Hi
I added print on line 245 and on iphone 6 can receive complete image data and display but on Iphone X , iphone X Max the data will stop before image data complete
https...
Does nrf 52840 have an inbuilt temperature sensor? I am getting some values when i see them through hercules software, so are these garbage values or internal board temperature...
Hello, I am developing a BLE application using nRF51822 on SDK 12.3 and SD 2.0.1.
I have an application with NUS service, in which I set the device name by sd_ble_gap_device_name_set...
Hello, I would like know if it is possible to play a buzzer using the Low-power PWM Library ? I am using the nrf51 DK and Softdevice130. The SDK I use is version SDK V 12...
Hi,
I just had a quick question - currently I'm using standard drive mode for everything, however in one case I'm driving an IR transmitter that could really do with a...
Environment: Ubuntu 18.04 Desktop with GNU ARM toolchain (gcc-arm-none-eabi-7-2018-q2-update), nRF5X SDK (nRF5_SDK_15.0.0_a53641a), nrfjprog , J-Link device and PCA10056 ...
Hi,
Device should run clock without stopping.
So one of RTC should run.
And device will run NUS peripheral.
In such conditions, i know that i should not use sd_power_system_off...
Hi, I am trying to develop my own board with on board nrf24L01+ coupled with ATMEGA328p . I want to know if there is any schematic of the same in EAGLE or if you have the...
Hi, I try to read data from the ICM20948 IMU with I2C from my nRF 52840 DK.
Initialization of the device is correct, the IMU ID is sent to nRF correctly which means that...
Hi I am working on nRF52832 board.
i am using fds library to store my data. data contains MAC address. Each MAC address is stored in each record with same file ID and key...
