Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi - I have an application where I sometimes get an NRF_ERROR_INVALID_STATE error on disconnect when the distance between the client and server is beyond certain limits. ...
Hello to everyone. I´m trying to configure the buttons of my SDK nRF52 to turn on LEDs, but all the examples I´ve found here are using BSP_EVENT_HANDLER. So, my question is...
Hi,
I am developing an application on an nrf52840 based custom board that includes a dfu bootloader. Currently this bootloader is the example secure one. This will be tweaked...
Hi,
I spent a lot of today trying to get or even to find instructions on how to get log messages (RTT) out of both the app and the bootloader I am working on. This was the...
Hello all!
I tried to develop a small BLE application and got stuck with endless loop in nrfx_uarte_tx() function (nrfx_uarte.c driver) which loops endlessly in these lines...
Hi, I am running Segger Embedded Studio (4.10a) to get used to the Nordic DK for the nRF52840. Now I have found, that the register display seems not to be able to show some...
Hello,
just a quick question for my understanding: If I use differential mode and have the Vp and Vn pins as an input channel to the SAADC, then may I only supply Vp with...
Hi,
I followed the example nRF5_SDK_15.2.0_9412b96\examples\ble_peripheral\ble_app_buttonless_dfu to add DFU service into my 3 programs. One has HTS service, one has HRS...
I have a custom board with nrf52840 with cr2477 battery (1Ah capacity). I was download firmware to board and after a week the battery voltage dropped to critical. In the firmware...
Hello,
I want to access the nrf9160 over UART from other controller My main concern is to program nrf9160 to respond with at commands from external microcontroller. (Just...
Hi everybody!
I hope I am not too late to jump on the nrf51 train, but I had the ability to get a great deal on them so I really want to use them for a project we have....
I am facing a strange issue where I removed all code related to the app_uart from the UART example. Now the logs are being dropped. Anyone know why this happens?
Hi,
For a few days, the nrfcloud device screen is not showing the sim card total data usage.
The console shows this error:
Failed to load resource: the server responded...
hello,
i am developing a health care device and i am using nrf52 dk board for development , i want my device to communicate to the android app, and i have zero experience...
