Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hello, I am unable to connect thingy 52 with my laptop, I have NRF connect v2.6.1 installed but it is unable to find thingy.
Thingy is not connected with any other device...
hello,
I am using the SDK15.2 for development.
I want to set a central address in peripheral like the whitelist function via uart without bonding.
This code is about...
Hello,
We are working with nrf52832 which have a custom application with SDK 13.1 and softdevice s132_nrf52_4.0.5_softdevice, we have migrated to sdk 15.2 s132_nrf52_6.1...
Hello,
I am trying to program my nrf52840 dongle to act as a BLE central device and I am using the USB CDC ACM Module. I am facing the following issues:
1- I was able...
Hi.
Softdevice 6.0.0
SDK 15.0.0
IDE IAR 7.80.4
Chip NRF52832
I buid progect buttonless DFU in IAR.
I added peer_id.c, peer_data_storage.c, peer_database.c, peer_manager...
I have successfully written the public certificate (type 1) using nrf_inbuilt_key_write().
When I then try to delete it with nrf_inbuilt_key_delete(), however, it returns...
Hello All,
Does the module have internal regulators that can be used to power connected peripherals? There is the 1.8V output for Sim_1V8. Is this strictly dedicated to...
Hi Everyone,
I am using the following peripherals in my project
2 UARTE.
2 ADC
1 TWI
BLE
GPIOTE interrupt for 2 buttons
TWI and ADC and BLE and GPIOTE are not...
Hi there,
I cannot find a good example of one central and one peripheral, where they use a passkey between them, with one of them, the peripheral, is where the user type...
i am using ble central example from sdk15.the peripheral i want to connect with Nrf52832 is not a Nordic device.Peripheral have 5 different services.now till i successfully...
Hi Nordic,
I am using Segger IDE on windows 10 to verify the mpu9250 functionality based on nRF52832.My doubt is that do we need to have two interrupt pins i.e., one for...
