Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Hi all
i'm new in both this site and nrf52
i have a question
Is there ADC CONFIG register in nrf52? i can't find ADC_CONFIG in nrf52
NRF_ADC->CONFIG = (ADC_CONFIG_EXTREFSEL_None...
I have an application where I am sending a fixed packet length of 32 bytes to data pipe 1.
I have set the data width to 32,
I have auto acknowledge enabled on P1.
I...
Hi,
I designed a nRF52832_xxAA board, I can't find the bluetooth name in iphone - settings - Bluetooth - Devices, but I can read/write and notify in myself mobile app and...
Hello,
I am using sdk version 15.2.0 and nrf52840. In the application NAND flash TC58CYG2S0HRAIG is used. We are using flash to store values which we receive from the USB...
1.I want to know whether there is any existing network in the same channel .And get the existing network's information like PAN ID.
Any APIs to do this?
2.How to set...
Hi,
I'm trying to run a display using SPI, and I've run into some troubles. I've attached my code below:
My issue is that the program never gets past the while loop...
Hi,
I am getting the GATT ERROR during init packet stage during firmware upgrade. I am using SDK 14.2 and nRFConnect application on Samsusng Galaxt S8. It looks like I am...
Dear Team
We have selected nRF52840 in our design.
I am layout designeer.
Please send refenrence layout section for nRF52840 to me.
I want study rhe layout design...
Hi,
I am currently developing Bluetooth Mesh for our battery powered products which needs to be updated on demand.
I am running the Mesh light switch examples on the...
Hi,
I'm completely new to the Bluetooth trying to understand a thing or two.
Bluetooth 5 comes with Mesh support and NRF52 supports it with Mesh SDK.
Now my Questions...
Stack - nRF52 DK, SDK 15.0.0, Segger Embedded Studio, Windows. Using code examples described below.
So my high level goal is to read data from registers in an I2C sensor...
How can I relocate or manage the transition between the bootloaders interrupt vector map and the applications interrupt vector map which will be at different addresses in...
Hi All
Working with my nRF52840 DK board and running the BLE Central & Peripheral\ Experimental CLI interface example, I customized my DEVICE_NAME to get it advertised as...
