Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi,
I'm doing a test with a test harness. An error occurs in test case TC-CNET-4.16. I would like to know how to solve this problem.
environment
・TH raspberry pi 4 Version...
Hello everyone,
I am currently facing the issue that migrating to NCS 2.9.0 is not possible as I get the following compile error:
Someone else had the same issue: Unfortunately...
Hello,
This morning I thought I would investigate the current consumption of some of the examples in the nRF connect SDK Fundamentals using the nRF9151DK and the PPK II...
Hi there,
Can you please help me with setup Platform independent driver from ST with Zephyr?
STMicroelectronics/lis2dh12-pid: lis2dh12 platform independent driver based...
Dear devzone, nRF54L15 runs private 2.4g, and needs to switch from 2400MHz to 2500MHz. How long is this period? How long is it to switch from 2400MHz to 2410MHz? I see from...
Dear Nordic,
Do we have ready-to-use keyboard driver with scanning/debouncing?
I've not found an example or docs about using KSCAN with gpio-connected keyboard...
The chip I am using is 54l15, and the NCS version is 2.8.0
I used the peripheral_uart example for modification and got my own program, but I forgot which time this problem...
Hi Nordic
Asking this question to Nordic AI (right-down window), below was the answer.
The nRF9160 is a cellular IoT device, and its MTU size depends on the protocol...
I am programming a RAK4631 Board, which is of course based on the nrf52840 SoC. The BaseLine Device tree has no detail in the ADC Node so I have created an overlay. The RAK4631...
Toolchain v2.70, SDK v2.7.0, VS Code, Windows
The design has an eSIM and a regular SIM, with a switch driven by a GPIO line. We default to the regular SIM, but if the library...
Hello,
How can I check which crystal oscillator is configured for the nRF52832 DK from the firmware side? Is there a specific configuration file or parameter that defines...
Hello,
I have a Python script that analyses some sensor data. If a condition is met I want to send a trigger via ESB to a peripheral board (ESB chosen for its low latency...
